From: Ian Abbott <abbotti@xxxxxxxxx>
Store PCI device IDs in the board info and use this for matching IDs in
the code instead of using the module device table.
This avoids a "section mismatch" error.
Signed-off-by: Frank Mori Hess <fmhess@xxxxxxxxxxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxx>
---
drivers/staging/comedi/drivers/cb_pcidio.c | 8 ++++++--
1 files changed, 6 insertions(+), 2 deletions(-)
diff --git a/drivers/staging/comedi/drivers/cb_pcidio.c b/drivers/staging/comedi/drivers/cb_pcidio.c
index 4d10bc3..09e6e3b 100644
--- a/drivers/staging/comedi/drivers/cb_pcidio.c
+++ b/drivers/staging/comedi/drivers/cb_pcidio.c
@@ -53,7 +53,8 @@ Passing a zero for an option is the same as leaving it unspecified.
* Some drivers use arrays such as this, other do not.
*/
struct pcidio_board {
- const char *name; /* anme of the board */
+ const char *name; /* name of the board */
+ int dev_id;
int n_8255; /* number of 8255 chips on board */
/* indices of base address regions */
@@ -64,18 +65,21 @@ struct pcidio_board {
static const struct pcidio_board pcidio_boards[] = {
{
.name = "pci-dio24",
+ .dev_id = 0x0028,
.n_8255 = 1,
.pcicontroler_badrindex = 1,
.dioregs_badrindex = 2,
},
{
.name = "pci-dio24h",
+ .dev_id = 0x0014,
.n_8255 = 1,
.pcicontroler_badrindex = 1,
.dioregs_badrindex = 2,
},
{
.name = "pci-dio48h",
+ .dev_id = 0x000b,
.n_8255 = 2,
.pcicontroler_badrindex = 0,
.dioregs_badrindex = 1,
@@ -206,7 +210,7 @@ static int pcidio_attach(struct comedi_device *dev, struct comedi_devconfig *it)
continue;
/* loop through cards supported by this driver */
for (index = 0; index < ARRAY_SIZE(pcidio_boards); index++) {
- if (pcidio_pci_table[index].device != pcidev->device)
+ if (pcidio_boards[index].dev_id != pcidev->device)
continue;
/* was a particular bus/slot requested? */
--
1.6.4.2
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
