Probably because the original file was pre-processed by some
tool, both i40e.rst and iavf.rst files are using this character:
- U+2013 ('–'): EN DASH
meaning an hyphen when calling a command line application, which
is obviously wrong. So, replace them by an hyphen, ensuring
that it will be properly displayed as literals when building
the documentation.
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
---
.../networking/device_drivers/ethernet/intel/i40e.rst | 4 ++--
.../networking/device_drivers/ethernet/intel/iavf.rst | 2 +-
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/Documentation/networking/device_drivers/ethernet/intel/i40e.rst b/Documentation/networking/device_drivers/ethernet/intel/i40e.rst
index 8a9b18573688..2d3f6bd969a2 100644
--- a/Documentation/networking/device_drivers/ethernet/intel/i40e.rst
+++ b/Documentation/networking/device_drivers/ethernet/intel/i40e.rst
@@ -173,7 +173,7 @@ Director rule is added from ethtool (Sideband filter), ATR is turned off by the
driver. To re-enable ATR, the sideband can be disabled with the ethtool -K
option. For example::
- ethtool –K [adapter] ntuple [off|on]
+ ethtool -K [adapter] ntuple [off|on]
If sideband is re-enabled after ATR is re-enabled, ATR remains enabled until a
TCP-IP flow is added. When all TCP-IP sideband rules are deleted, ATR is
@@ -688,7 +688,7 @@ shaper bw_rlimit: for each tc, sets minimum and maximum bandwidth rates.
Totals must be equal or less than port speed.
For example: min_rate 1Gbit 3Gbit: Verify bandwidth limit using network
-monitoring tools such as ifstat or sar –n DEV [interval] [number of samples]
+monitoring tools such as `ifstat` or `sar -n DEV [interval] [number of samples]`
2. Enable HW TC offload on interface::
diff --git a/Documentation/networking/device_drivers/ethernet/intel/iavf.rst b/Documentation/networking/device_drivers/ethernet/intel/iavf.rst
index 52e037b11c97..25330b7b5168 100644
--- a/Documentation/networking/device_drivers/ethernet/intel/iavf.rst
+++ b/Documentation/networking/device_drivers/ethernet/intel/iavf.rst
@@ -179,7 +179,7 @@ shaper bw_rlimit: for each tc, sets minimum and maximum bandwidth rates.
Totals must be equal or less than port speed.
For example: min_rate 1Gbit 3Gbit: Verify bandwidth limit using network
-monitoring tools such as ifstat or sar –n DEV [interval] [number of samples]
+monitoring tools such as ``ifstat`` or ``sar -n DEV [interval] [number of samples]``
NOTE:
Setting up channels via ethtool (ethtool -L) is not supported when the
--
2.30.2
