Since the CSI controller binding is getting a bit more complex due
to the addition of MIPI CSI-2 bridge support, make the ports node
explicit with the parallel port.
This way, it's clear that the controller only supports parallel
interface input and there's no confusion about the port number.
Signed-off-by: Paul Kocialkowski <paul.kocialkowski@xxxxxxxxxxx>
---
arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
index 51cc30e84e26..1e1f0d2097d5 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
@@ -1109,6 +1109,15 @@ csi: csi@1cb0000 {
pinctrl-names = "default";
pinctrl-0 = <&csi_pins>;
status = "disabled";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ csi_in_parallel: port@0 {
+ reg = <0>;
+ };
+ };
};
dsi: dsi@1ca0000 {
--
2.29.2
