[RFC PATCH 08/22] rpmsg: virtio_rpmsg_bus: Disable receive virtqueue callback when reading messages

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Since rpmsg_recv_done() reads messages in a while loop, disable
callbacks until the while loop exits. This helps to get rid of the
annoying "uhm, incoming signal, but no used buffer ?" message.

Signed-off-by: Kishon Vijay Abraham I <kishon@xxxxxx>
---
 drivers/rpmsg/virtio_rpmsg_bus.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/rpmsg/virtio_rpmsg_bus.c b/drivers/rpmsg/virtio_rpmsg_bus.c
index 376ebbf880d6..2d0d42084ac0 100644
--- a/drivers/rpmsg/virtio_rpmsg_bus.c
+++ b/drivers/rpmsg/virtio_rpmsg_bus.c
@@ -777,6 +777,7 @@ static void rpmsg_recv_done(struct virtqueue *rvq)
 		return;
 	}
 
+	virtqueue_disable_cb(rvq);
 	while (msg) {
 		err = rpmsg_recv_single(vrp, dev, msg, len);
 		if (err)
@@ -786,6 +787,19 @@ static void rpmsg_recv_done(struct virtqueue *rvq)
 
 		msg = virtqueue_get_buf(rvq, &len);
 	}
+	virtqueue_enable_cb(rvq);
+
+	/*
+	 * Try to read message one more time in case a new message is submitted
+	 * after virtqueue_get_buf() inside the while loop but before enabling
+	 * callbacks
+	 */
+	msg = virtqueue_get_buf(rvq, &len);
+	if (msg) {
+		err = rpmsg_recv_single(vrp, dev, msg, len);
+		if (!err)
+			msgs_received++;
+	}
 
 	dev_dbg(dev, "Received %u messages\n", msgs_received);
 
-- 
2.17.1




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux