Recently, I switched over from swap-file to zramswap.
When reading the Documentation/vm/zswap.rst file I fell over this typo.
The parameter is called accept_threshold_percent not accept_threhsold_percent
in /sys/module/zswap/parameters/ directory.
Fixes: 45190f01dd402 ("mm/zswap.c: add allocation hysteresis if pool limit is hit")
Cc: Vitaly Wool <vitaly.wool@xxxxxxxxxxxx>
Signed-off-by: Sedat Dilek <sedat.dilek@xxxxxxxxx>
---
Changes v1->v2:
- Changed subject line
- Resend to LKML with correct email-address
Documentation/vm/zswap.rst | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/vm/zswap.rst b/Documentation/vm/zswap.rst
index f8c6a79d7c70..d8d9fa4a1f0d 100644
--- a/Documentation/vm/zswap.rst
+++ b/Documentation/vm/zswap.rst
@@ -140,10 +140,10 @@ without any real benefit but with a performance drop for the system), a
special parameter has been introduced to implement a sort of hysteresis to
refuse taking pages into zswap pool until it has sufficient space if the limit
has been hit. To set the threshold at which zswap would start accepting pages
-again after it became full, use the sysfs ``accept_threhsold_percent``
+again after it became full, use the sysfs ``accept_threshold_percent``
attribute, e. g.::
- echo 80 > /sys/module/zswap/parameters/accept_threhsold_percent
+ echo 80 > /sys/module/zswap/parameters/accept_threshold_percent
Setting this parameter to 100 will disable the hysteresis.
--
2.27.0.rc2
