On Wed, 2020-02-26 at 10:05 -0800, Dave Hansen wrote:
> On 2/5/20 10:19 AM, Yu-cheng Yu wrote:
> > +# Check assembler Shadow Stack suppot
>
> ^ support
>
> > +ifdef CONFIG_X86_INTEL_SHADOW_STACK_USER
> > + ifeq ($(call as-instr, saveprevssp, y),)
> > + $(error CONFIG_X86_INTEL_SHADOW_STACK_USER not supported by the assembler)
> > + endif
> > +endif
>
> Is this *just* looking for instruction support in the assembler?
>
> We usually just .byte them, like this for pkeys:
>
> asm volatile(".byte 0x0f,0x01,0xee\n\t"
> : "=a" (pkru), "=d" (edx)
> : "c" (ecx));
>
> That way everybody with old toolchains can still build the kernel (and
> run/test code with your config option on, btw...).
We used to do this for CET instructions, but after adding kernel-mode
instructions and inserting ENDBR's, the code becomes cluttered. I also
found an earlier discussion on the ENDBR:
https://lore.kernel.org/lkml/CALCETrVRH8LeYoo7V1VBPqg4WS0Enxtizt=T7dPvgoeWfJrdzA@xxxxxxxxxxxxxx/
It makes sense to let the user know early on that the system cannot support
CET and cannot build a CET-enabled kernel.
One thing we can do is to disable CET in Kconfig and not in kernel
build, which I will do in the next version.
Yu-cheng
