Use the resolved link configuration to set the MAC configuration when mac_link_up() for non-internal-PHY ports. Signed-off-by: Russell King <rmk+kernel@xxxxxxxxxxxxxxx> --- drivers/net/dsa/mv88e6xxx/chip.c | 75 +++++++++++++++++++++++++------- 1 file changed, 59 insertions(+), 16 deletions(-) diff --git a/drivers/net/dsa/mv88e6xxx/chip.c b/drivers/net/dsa/mv88e6xxx/chip.c index fef3b5e0b291..4a4173e63fa5 100644 --- a/drivers/net/dsa/mv88e6xxx/chip.c +++ b/drivers/net/dsa/mv88e6xxx/chip.c @@ -632,25 +632,30 @@ static void mv88e6xxx_mac_config(struct dsa_switch *ds, int port, dev_err(ds->dev, "p%d: failed to configure MAC\n", port); } -static void mv88e6xxx_mac_link_force(struct dsa_switch *ds, int port, int link) +static void mv88e6xxx_mac_link_down(struct dsa_switch *ds, int port, + unsigned int mode, + phy_interface_t interface) { struct mv88e6xxx_chip *chip = ds->priv; - int err; + const struct mv88e6xxx_ops *ops; + int err = 0; - mv88e6xxx_reg_lock(chip); - err = chip->info->ops->port_set_link(chip, port, link); - mv88e6xxx_reg_unlock(chip); + ops = chip->info->ops; - if (err) - dev_err(chip->dev, "p%d: failed to force MAC link\n", port); -} + /* Internal PHYs propagate their configuration directly to the MAC. + * External PHYs depend on whether the PPU is enabled for this port. + * FIXME: we should be using the PPU enable state here. What about + * an automedia port? + */ + if (!mv88e6xxx_phy_is_internal(ds, port) && ops->port_set_link) { + mv88e6xxx_reg_lock(chip); + err = ops->port_set_link(chip, port, LINK_FORCED_DOWN); + mv88e6xxx_reg_unlock(chip); -static void mv88e6xxx_mac_link_down(struct dsa_switch *ds, int port, - unsigned int mode, - phy_interface_t interface) -{ - if (mode == MLO_AN_FIXED) - mv88e6xxx_mac_link_force(ds, port, LINK_FORCED_DOWN); + if (err) + dev_err(chip->dev, + "p%d: failed to force MAC link down\n", port); + } } static void mv88e6xxx_mac_link_up(struct dsa_switch *ds, int port, @@ -659,8 +664,46 @@ static void mv88e6xxx_mac_link_up(struct dsa_switch *ds, int port, int speed, int duplex, bool tx_pause, bool rx_pause) { - if (mode == MLO_AN_FIXED) - mv88e6xxx_mac_link_force(ds, port, LINK_FORCED_UP); + struct mv88e6xxx_chip *chip = ds->priv; + const struct mv88e6xxx_ops *ops; + int err = 0; + + ops = chip->info->ops; + + /* Internal PHYs propagate their configuration directly to the MAC. + * External PHYs depend on whether the PPU is enabled for this port. + * FIXME: we should be using the PPU enable state here. What about + * an automedia port? + */ + if (!mv88e6xxx_phy_is_internal(ds, port)) { + mv88e6xxx_reg_lock(chip); + /* FIXME: for an automedia port, should we force the link + * down here - what if the link comes up due to "other" media + * while we're bringing the port up, how is the exclusivity + * handled in the Marvell hardware? E.g. port 4 on 88E6532 + * shared between internal PHY and Serdes. + */ + if (ops->port_set_speed) { + err = ops->port_set_speed(chip, port, speed); + if (err && err != -EOPNOTSUPP) + goto error; + } + + if (ops->port_set_duplex) { + err = ops->port_set_duplex(chip, port, duplex); + if (err && err != -EOPNOTSUPP) + goto error; + } + + if (ops->port_set_link) + err = ops->port_set_link(chip, port, LINK_FORCED_UP); +error: + mv88e6xxx_reg_unlock(chip); + + if (err && err != -EOPNOTSUPP) + dev_err(ds->dev, + "p%d: failed to configure MAC link up\n", port); + } } static int mv88e6xxx_stats_snapshot(struct mv88e6xxx_chip *chip, int port) -- 2.20.1