Re: [PATCH v10 0/9] Add the I3C subsystem

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



+Mark Brown for the question about /dev/spidev

Hi Vitor,

On Thu, 15 Nov 2018 12:14:37 +0000
vitor <vitor.soares@xxxxxxxxxxxx> wrote:

> Hi Boris,
> 
> Given the current state of the subsystem I think it might worth start to 
> think how to expose the devices under /dev.

Thanks for starting this discussion. I'm not against the idea in
general, we just need to be careful when doing that.

> My initial thoughts are to do the same think as for i2c, expose the 
> buses or the i3c_devices and use ioctl for private transfers.

Exposing the bus is dangerous IMO, because an I3C bus is not like an
I2C bus:

   * I3C device needs to be discovered through DAA
   * I2C devices need to be declared ahead of time, and LVR is used to
     determine the limitations on the bus at runtime

So you'd anyway be able to interact only with devices that have
previously been discovered.

Note that the virtual I2C bus is already exposed, but any command
targeting an address that is not attached to a registered I2C dev will
get a -ENOENT error.

What we could do though, is expose I3C devices that do not have a
driver in kernel space, like spidev does.

> Some 
> direct CCC commands can be sent through the /sys as you plan for SETNEWDA .

Yes, CCC commands that need to be exposed to userspace should be
exposed through sysfs, or, if we decide to create a /dev/i3cX device
per bus, through ioctls.

> 
> What do you think about this?

I think this request is perfectly valid, we just need to decide how it
should be done, and before we take this decision, I'd like to get
inputs from other maintainers.

Mark, Wolfram, Arnd, Greg, any opinion?

Regards,

Boris



[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux