On Sat, 5 Mar 2016, Rob Herring wrote:
> On Thu, Feb 25, 2016 at 05:25:07PM -0600, Alan Tull wrote:
> > Add bindings documentation for Altera SOCFPGA bridges:
> > * fpga2sdram
> > * fpga2hps
> > * hps2fpga
> > * lwhps2fpga
> >
> > Signed-off-by: Alan Tull <atull@xxxxxxxxxxxxxxxxxxxxx>
> > Signed-off-by: Matthew Gerlach <mgerlach@xxxxxxxxxx>
> > Signed-off-by: Dinh Nguyen <dinguyen@xxxxxxxxxxxxxxxxxxxxx>
> > ---
> > v2: separate into 2 documents for the 2 drivers
> > v12: bump version to line up with simple-fpga-bus version
> > remove Linux specific notes such as references to sysfs
> > move non-DT specific documentation elsewhere
> > remove bindings that would have been used to pass configuration
> > clean up formatting
> > v13: Remove 'label' property
> > Change property from init-val to bridge-enable
> > Fix email address
> > v14: Add resets
> > Change order of bridges to put lw bridge (controlling bridge) first
> > v15: No change in this patch for v15 of this patch set
> > v16: Added regs property, cleaned up unit addresses
> > v17: No change to this patch in v17 of patch set
> > ---
> > .../bindings/fpga/altera-fpga2sdram-bridge.txt | 15 +++++++
> > .../bindings/fpga/altera-hps2fpga-bridge.txt | 47 ++++++++++++++++++++
> > 2 files changed, 62 insertions(+)
> > create mode 100644 Documentation/devicetree/bindings/fpga/altera-fpga2sdram-bridge.txt
> > create mode 100644 Documentation/devicetree/bindings/fpga/altera-hps2fpga-bridge.txt
>
> Just a few minor things.
>
> > diff --git a/Documentation/devicetree/bindings/fpga/altera-fpga2sdram-bridge.txt b/Documentation/devicetree/bindings/fpga/altera-fpga2sdram-bridge.txt
> > new file mode 100644
> > index 0000000..4479a79
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/fpga/altera-fpga2sdram-bridge.txt
> > @@ -0,0 +1,15 @@
> > +Altera FPGA To SDRAM Bridge Driver
> > +
> > +Required properties:
> > +- compatible : Should contain "altr,socfpga-fpga2sdram-bridge"
> > +
> > +Optional properties:
> > +- bridge-enable : 0 if driver should disable bridge at startup
> > + 1 if driver should enable bridge at startup
> > + Default is to leave bridge in current state.
> > +
> > +Example:
> > + fpga2sdram_br {
>
> fpga-bridge@??
The hardware is messy here as the control of this bridge is
lumped into the sdram controller. I could give the address
of the one register that enables/disable the bridge here.
>
> > + compatible = "altr,socfpga-fpga2sdram-bridge";
> > + bridge-enable = <0>;
> > + };
> > diff --git a/Documentation/devicetree/bindings/fpga/altera-hps2fpga-bridge.txt b/Documentation/devicetree/bindings/fpga/altera-hps2fpga-bridge.txt
> > new file mode 100644
> > index 0000000..e6b7474
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/fpga/altera-hps2fpga-bridge.txt
> > @@ -0,0 +1,47 @@
> > +Altera FPGA/HPS Bridge Driver
> > +
> > +Required properties:
> > +- regs : base address and size for AXI bridge module
> > +- compatible : Should contain one of:
> > + "altr,socfpga-lwhps2fpga-bridge",
> > + "altr,socfpga-hps2fpga-bridge", or
> > + "altr,socfpga-fpga2hps-bridge"
> > +- reset-names : Should contain one of:
> > + "lwhps2fpga",
> > + "hps2fpga", or
> > + "fpga2hps"
>
> Names should be the input signal names. Do you need names with only one?
Right, I will use
of_reset_control_get_by_index(dev->of_node, 0) and eliminate
the reset-names here.
>
> > +- resets : Phandle and reset specifier for the reset listed in
> > + reset-names
> > +- clocks : Clocks used by this module.
> > +
> > +Optional properties:
> > +- bridge-enable : 0 if driver should disable bridge at startup.
> > + 1 if driver should enable bridge at startup.
> > + Default is to leave bridge in its current state.
> > +
> > +Example:
> > + hps_fpgabridge0: fpgabridge@ff400000 {
>
> No underscores.
>
> fpga-bridge@...
OK, will add these fixes in v18.
>
> > + compatible = "altr,socfpga-lwhps2fpga-bridge";
> > + reg = <0xff400000 0x100000>;
> > + resets = <&rst LWHPS2FPGA_RESET>;
> > + reset-names = "lwhps2fpga";
> > + clocks = <&l4_main_clk>;
> > + bridge-enable = <0>;
> > + };
> > +
> > + hps_fpgabridge1: fpgabridge@ff500000 {
> > + compatible = "altr,socfpga-hps2fpga-bridge";
> > + reg = <0xff500000 0x10000>;
> > + resets = <&rst HPS2FPGA_RESET>;
> > + reset-names = "hps2fpga";
> > + clocks = <&l4_main_clk>;
> > + bridge-enable = <1>;
> > + };
> > +
> > + hps_fpgabridge2: fpgabridge@ff600000 {
> > + compatible = "altr,socfpga-fpga2hps-bridge";
> > + reg = <0xff600000 0x100000>;
> > + resets = <&rst FPGA2HPS_RESET>;
> > + reset-names = "fpga2hps";
> > + clocks = <&l4_main_clk>;
> > + };
> > --
> > 1.7.9.5
> >
>
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
