From: "H. Nikolaus Schaller" <hns@xxxxxxxxxxxxx> While trying to test the Pyra GSM/GPS/3G module I had reconfigured the USB interface by mistake and therefore needed to run a different USB driver than CSC-ACM. It turned out that I need the "usbserial" driver. This file is an official description how to use it: Documentation/usb/usb-serial.txt But it is outdated. The parameters vendor= and product= are no longer available since ca. 3.12 which means that documentation is lagging behind quite some time. Here was the solution: https://bbs.archlinux.org/viewtopic.php?id=175499 insmod usbserial vendor=0x#### product=0x#### becomes (first #### is vendor, second is product) modprobe usbserial echo #### #### >/sys/bus/usb-serial/drivers/generic/new_id This patch changes the documentation file as needed. Signed-off-by: H. Nikolaus Schaller <hns@xxxxxxxxxxxxx> Signed-off-by: Marek Belisko <marek@xxxxxxxxxxxxx> --- Documentation/usb/usb-serial.txt | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-) diff --git a/Documentation/usb/usb-serial.txt b/Documentation/usb/usb-serial.txt index 947fa62..9f184d8 100644 --- a/Documentation/usb/usb-serial.txt +++ b/Documentation/usb/usb-serial.txt @@ -466,11 +466,13 @@ Generic Serial driver is required of your device is that it has at least one bulk in endpoint, or one bulk out endpoint. - To enable the generic driver to recognize your device, build the driver - as a module and load it by the following invocation: - insmod usbserial vendor=0x#### product=0x#### - where the #### is replaced with the hex representation of your device's - vendor id and product id. + To enable the generic driver to recognize your device, configure + USB_SERIAL_GENERIC=y and build the driver as a module. Then load it by the + following invocation: + modprobe usbserial + echo #### #### >/sys/bus/usb-serial/drivers/generic/new_id + where the the first #### is replaced with the hex representation of your + device's vendor id and the second #### by the product id. This driver has been successfully used to connect to the NetChip USB development board, providing a way to develop USB firmware without -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
