Hi Linus, On Mon, 2014-07-07 at 04:51PM +0200, Linus Walleij wrote: > On Wed, Jun 18, 2014 at 5:36 PM, Sören Brinkmann > <soren.brinkmann@xxxxxxxxxx> wrote: > > > I did some of the changes for this v2 and a few things are not clear to > > me. > > > > The first is, how is userspace supposed to find the correct offset for a > > GPIO pin. > > The sysfs interface to GPIO is *NOT* *GOOD* this is universally > agreed upon. > > This needs someone to step in and provide a replacement, my preferred > mechanism would be a /dev/gpiochip0/... hierarchy using char devices. > > > E.g. let's say GPIO 10 of this SOC-internal GPIO controller is > > something I want to control. So, I'd export GPIO (chip-base + 10). But > > this chip-base seems pretty variable. v1 of this patch had it hardcoded > > to 0, which resulted in a predictable offset, but apparently was utterly > > wrong. Now I see an offset of 138 for this chip when using my config. > > And when I use multi_v7_defconfig the offset is somewhere in the 800s, > > IIRC. The best I found was the 'label' in the gpiochip's sysfs entry, > > but documentation says that is not necessarily unique, and parsing labes > > seems sub-optimal too. > > You see. It is badly designed and needs to be rewritten. > > It was merged into the kernel at a time when the GPIO subsystem > was unmaintained, sadly. > > > The second issue is a stack trace (below) I see when triggering > > interrupts (e.g. echo rising > edge; and then pushing the connected > > button). Looking at the stack trace, I don't see an obvious error (I > > think I pretty much copied the IRQ registration from the gpio-pl061.c > > driver you mentioned). Is this an issue in this driver or the core code? > > Probably. > > Using GPIOs for IRQs in userspace is an even worse idea than using > GPIOs from userspace in general :-D > > But before you add any hairy code in userspace, please have a look > at Documentation/gpio/sysfs.txt: > > "Note that standard kernel drivers exist for common "LEDs and Buttons" > GPIO tasks: "leds-gpio" and "gpio_keys", respectively. Use those > instead of talking directly to the GPIOs; they integrate with kernel > frameworks better than your userspace code could." > > So: what is the usecase for these GPIOs? Yea, in this case it was a button. I have to look at these drivers. It's very likely that they cover what I want. But this case is trivial. I really don't do anything but enabling the IRQ by writing to the edge attribute and press the push-button connected to that GPIO line. But as a general note: I think we have quite some customers trying to do GPIO in userspace. With Zynq's FPGA portion, a lot of things come down to make signals accessible in Linux and a lot of people do not want or need a full blown kernel driver and use GPIO. The request for 'how to handle GPIO IRQs in userspace' is pretty common. Often this gets passed on to UIO though. Thanks for the answers. Sören -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
