ETHTOOL_MSG_PHY_GET/GET_REPLY/NTF is missing in the ethtool message list. Add it to the ethool netlink documentation. Signed-off-by: Kory Maincent <kory.maincent@xxxxxxxxxxx> --- Change in v2: - Change PHY_NTF documentation --- Documentation/networking/ethtool-netlink.rst | 3 +++ 1 file changed, 3 insertions(+) diff --git a/Documentation/networking/ethtool-netlink.rst b/Documentation/networking/ethtool-netlink.rst index 295563e91082..b25926071ece 100644 --- a/Documentation/networking/ethtool-netlink.rst +++ b/Documentation/networking/ethtool-netlink.rst @@ -236,6 +236,7 @@ Userspace to kernel: ``ETHTOOL_MSG_MM_GET`` get MAC merge layer state ``ETHTOOL_MSG_MM_SET`` set MAC merge layer parameters ``ETHTOOL_MSG_MODULE_FW_FLASH_ACT`` flash transceiver module firmware + ``ETHTOOL_MSG_PHY_GET`` get Ethernet PHY information ===================================== ================================= Kernel to userspace: @@ -283,6 +284,8 @@ Kernel to userspace: ``ETHTOOL_MSG_PLCA_NTF`` PLCA RS parameters ``ETHTOOL_MSG_MM_GET_REPLY`` MAC merge layer status ``ETHTOOL_MSG_MODULE_FW_FLASH_NTF`` transceiver module flash updates + ``ETHTOOL_MSG_PHY_GET_REPLY`` Ethernet PHY information + ``ETHTOOL_MSG_PHY_NTF`` Ethernet PHY information change ======================================== ================================= ``GET`` requests are sent by userspace applications to retrieve device -- 2.34.1
