Since the pwm was introduced before backend, there was an example use whit triggered buffers. However, using it may be dangerous, because if the PWM goes too fast, a new conversion can be triggered before the transmission is over, whit the associated mess in the buffers. Until a solution is found to mitigate this risk, for instante CRC support, the PWM will be disabled. Signed-off-by: Guillaume Stols <gstols@xxxxxxxxxxxx> --- drivers/iio/adc/ad7606.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-) diff --git a/drivers/iio/adc/ad7606.c b/drivers/iio/adc/ad7606.c index f710445bdc22..0c12ca237ee9 100644 --- a/drivers/iio/adc/ad7606.c +++ b/drivers/iio/adc/ad7606.c @@ -599,7 +599,6 @@ static int ad7606_buffer_postenable(struct iio_dev *indio_dev) struct ad7606_state *st = iio_priv(indio_dev); gpiod_set_value(st->gpio_convst, 1); - ad7606_pwm_set_swing(st); return 0; } @@ -609,7 +608,6 @@ static int ad7606_buffer_predisable(struct iio_dev *indio_dev) struct ad7606_state *st = iio_priv(indio_dev); gpiod_set_value(st->gpio_convst, 0); - ad7606_pwm_set_low(st); return 0; } @@ -838,6 +836,12 @@ int ad7606_probe(struct device *dev, int irq, void __iomem *base_address, indio_dev->setup_ops = &ad7606_pwm_buffer_ops; } else { init_completion(&st->completion); + + /* Reserve the PWM use only for backend (force gpio_convst definition) */ + if (!st->gpio_convst) + return dev_err_probe(dev, -EINVAL, + "No backend, connect convst to a GPIO"); + ret = devm_request_threaded_irq(dev, irq, NULL, &ad7606_interrupt, -- 2.34.1