Building external modules is typically done using this command: $ make -C <KERNEL_DIR> M=<EXTMOD_DIR> Here, <KERNEL_DIR> refers to the output directory where the kernel was built, not the kernel source directory. When the kernel is built in the source tree, there is no ambiguity, as the output directory and the source directory are the same. If the kernel was built in a separate build directory, <KERNEL_DIR> should be the kernel output directory. Otherwise, Kbuild cannot locate necessary build artifacts such as the .config file, etc. This has been the method for building external modules against a pre-built kernel in a separate directory for over 20 years. [1] If you pass the kernel source directory to the -C option, you must also specify the kernel build directory using the O= option. This approach works as well, though it results in a slightly longer command: $ make -C <KERNEL_SOURCE_DIR> O=<KERNEL_BUILD_DIR> M=<EXTMOD_DIR> Some people mistakenly believe that O= should point to a build directory for external modules when used together with M=. This commit adds more clarification to Documentation/kbuild/kbuild.rst. [1]: https://git.kernel.org/pub/scm/linux/kernel/git/history/history.git/commit/?id=e321b2ec2eb2993b3d0116e5163c78ad923e3c54 Signed-off-by: Masahiro Yamada <masahiroy@xxxxxxxxxx> Reviewed-by: Nicolas Schier <n.schier@xxxxxx> --- Changes in v2: - Rebase Documentation/kbuild/kbuild.rst | 5 +++++ Documentation/kbuild/modules.rst | 9 ++++++--- 2 files changed, 11 insertions(+), 3 deletions(-) diff --git a/Documentation/kbuild/kbuild.rst b/Documentation/kbuild/kbuild.rst index 9c8d1d046ea5..716f6fb70829 100644 --- a/Documentation/kbuild/kbuild.rst +++ b/Documentation/kbuild/kbuild.rst @@ -129,6 +129,11 @@ KBUILD_OUTPUT ------------- Specify the output directory when building the kernel. +This variable can also be used to point to the kernel output directory when +building external modules using kernel build artifacts in a separate build +directory. Please note that this does NOT specify the output directory for the +external modules themselves. + The output directory can also be specified using "O=...". Setting "O=..." takes precedence over KBUILD_OUTPUT. diff --git a/Documentation/kbuild/modules.rst b/Documentation/kbuild/modules.rst index 080e11372351..b24448f789b3 100644 --- a/Documentation/kbuild/modules.rst +++ b/Documentation/kbuild/modules.rst @@ -45,7 +45,7 @@ Command Syntax The command to build an external module is:: - $ make -C <path_to_kernel_src> M=$PWD + $ make -C <path_to_kernel_dir> M=$PWD The kbuild system knows that an external module is being built due to the "M=<dir>" option given in the command. @@ -62,12 +62,15 @@ Command Syntax Options ------- - ($KDIR refers to the path of the kernel source directory.) + ($KDIR refers to the path of the kernel source directory, or the path + of the kernel output directory if the kernel was built in a separate + build directory.) make -C $KDIR M=$PWD -C $KDIR - The directory where the kernel source is located. + The directory that contains the kernel and relevant build + artifacts used for building an external module. "make" will actually change to the specified directory when executing and will change back when finished. -- 2.43.0
