Re: [PATCH v24 23/34] ALSA: usb-audio: Prevent starting of audio stream if in use

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 8/8/2024 3:19 AM, Wesley Cheng wrote:
Hi Amadeusz,

On 8/6/2024 7:51 AM, Amadeusz Sławiński wrote:
On 8/1/2024 3:17 AM, Wesley Cheng wrote:
With USB audio offloading, an audio session is started from the ASoC
platform sound card and PCM devices.  Likewise, the USB SND path is still
readily available for use, in case the non-offload path is desired.  In
order to prevent the two entities from attempting to use the USB bus,
introduce a flag that determines when either paths are in use.


How can this happen? Can you provide some example with list of devices and which one should block the other? If I recall correctly devices are already exclusive unless you support substreams which ASoC does not at the moment.

 From past discussions, I think so far everyone is on board with the idea of having both the USB sound card and PCM devices exist in conjunction w/ the USB offload path, which is going to be done over the ASoC platform card.  So for example,


Sorry, I must have missed that and examples in documentation could probably be a bit better, it is bit late at patchset 24 that I understood about this now. And is part of a reason why I was confused about kcontrol implementation.

/ # cat /proc/asound/cards
  0 [SM8250MTPWCD938]: sm8250 - SM8250-MTP-WCD9380-WSA8810-VA-D
                       SM8250-MTP-WCD9380-WSA8810-VA-DMIC
  1 [C320M          ]: USB-Audio - Plantronics C320-M
                       Plantronics Plantronics C320-M at usb-xhci-hcd.1.auto-1.2, full speed

This device currently has the following sound cards within the system:

- card#0 - ASoC platform card: handles USB offload, speaker, etc...

- card#1 - USB SND card: card created for interacting with the connected USB device.

So now, with USB offloading in the picture, there are basically two paths that can start attempting to utilize the same USB device endpoints.  Let's keep it simple and assume the device only has one playback substream (which means only one PCM device)

/proc/asound/card1 # cat stream0
Plantronics Plantronics C320-M at usb-xhci-hcd.1.auto-1.2, full speed : USB Audio

Playback:
   Status: Stop
   Interface 2
     Altset 1
     Format: S16_LE
     Channels: 2
     Endpoint: 0x01 (1 OUT) (ADAPTIVE)
     Rates: 8000, 16000, 24000, 32000, 44100, 48000
     Bits: 16
     Channel map: FL FR

So the patch here will prevent transfers from happening from both the offload path and directly over the USB SND PCM device, which correlates to the following paths:

- offload: card#0 pcm#0

- USB SND: card#1 pcm#0

Well, it's one way to do that.

Personally I would just reuse USB FEs and when opening one check if it can be offloaded:
* check if someone disabled Offload on FE
* check if it is connected to HW that can do Offload at all
* check if Offload streams are available on backing HW
* check if audio formats are supported by above HW
* do any other checks that may be needed
and then just redirect FE setup to relevant driver doing offload if able, otherwise just go standard path.


As I've wrote I must have missed the discussion where it was agreed on and if maintainers agree that it can be done this way, I won't fight it. Even though I would consider my way a lot simpler and user friendly from end user point of view.

Thanks,
Amadeusz




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux