Re: [PATCH 0/6] mm: split underutilized THPs

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 05/08/2024 00:04, Usama Arif wrote:
> 
> 
> On 01/08/2024 07:36, David Hildenbrand wrote:
>>>> I just added a bunch of quick printfs to QEMU and ran a precopy+postcopy live migration. Looks like my assumption was right:
>>>>
>>>> On the destination:
>>>>
>>>> Writing received pages during precopy # ram_load_precopy()
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Writing received pages during precopy
>>>> Disabling THP: MADV_NOHUGEPAGE # postcopy_ram_prepare_discard()
>>>> Discarding pages # loadvm_postcopy_ram_handle_discard()
>>>> Discarding pages
>>>> Discarding pages
>>>> Discarding pages
>>>> Discarding pages
>>>> Discarding pages
>>>> Discarding pages
>>>> Registering UFFD # postcopy_ram_incoming_setup()
>>>>
>>>
>>> Thanks for this, yes it makes sense after you mentioned postcopy_ram_incoming_setup.
>>> postcopy_ram_incoming_setup happens in the Listen phase, which is after the discard phase, so I was able to follow in code in qemu the same sequence of events that the above prints show.
>>
>>
>> I just added another printf to postcopy_ram_supported_by_host(), where we temporarily do a UFFDIO_REGISTER on some test area.
>>
>> Sensing UFFD support # postcopy_ram_supported_by_host()
>> Sensing UFFD support
>> Writing received pages during precopy # ram_load_precopy()
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Writing received pages during precopy
>> Disabling THP: MADV_NOHUGEPAGE # postcopy_ram_prepare_discard()
>> Discarding pages # loadvm_postcopy_ram_handle_discard()
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Discarding pages
>> Registering UFFD # postcopy_ram_incoming_setup()
>>
>> We could think about using this "ever user uffd" to avoid the shared zeropage in most processes.
>>
>> Of course, there might be other applications where that wouldn't work, but I think this behavior (write to area before enabling uffd) might be fairly QEMU specific already.
>>
>> Avoiding the shared zeropage has the benefit that a later write fault won't have to do a TLB flush and can simply install a fresh anon page.
>>
> 
> I checked CRIU and that does a check at the start as well before attempting to use uffd: https://github.com/checkpoint-restore/criu/blob/criu-dev/criu/kerndat.c#L1349
> 
> If writing to an area before enabling uffd is likely to be QEMU specific, then you make a good point to clear pte instead of using shared zeropage to avoid the TLB flush if uffd is ever used.
> 
> I think "ever used uffd" would need to be tracked using mm_struct. This also won't cause an issue if the check is done in a parent process and the actual use is in a forked process, as copy_mm should take care of it.
> The possibilities would then be:
> 1) Have a new bit in mm->flags, set it in new_userfaultfd and test it in try_to_unmap_unused, but unfortunately all the bits in mm->flags are taken.
> 2) We could use mm->def_flags as it looks like there is an unused bit (0x800) just before VM_UFFD_WP. But that makes the code confusing as its used to initialize the default flags for VMAs and is not supposed to be used as a "mm flag".
> 3) Introducing mm->flags2 and set/test as 1. This would introduce a 8 byte overhead for all mm_structs.
> 
> I am not sure either 2 or 3 are acceptable upstream, unless there is a need for more flags in the near future and the 8 byte overhead starts to make sense. Maybe we go with shared zeropage?


There is an another option to use bit 32 of mm->flags for 64 bit kernel only for ever_used_uffd, but considering the 2 reasons below, I will send a v2 of the series (in a few days incase any more comments come up) with shared zeropage in all circumstances (and addressing the comments in the other patches).
- "ever used uffd" is not a 100% safe, i.e. someone might not check uffd support before using it and do the same sequence of events as qemu precopy + postcopy (+ some bitmap to track and check whether to request a page from uffd handler). Its very unlikely that anyone else does this, but we have to cater for all current and future usecases.
- If THP shrinker is splitting and pointing pages to a shared zeropage, then the page was considered "unused" and unlikely to have a write fault at some point in the near future, hence the probability of incurring that TLB flush on write fault is low.




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux