Fixed trivial typos to improve readability. Signed-off-by: Sachin Kamat <sachin.kamat@xxxxxxxxxx> --- Documentation/devicetree/bindings/mfd/s2mps11.txt | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/mfd/s2mps11.txt b/Documentation/devicetree/bindings/mfd/s2mps11.txt index c9332c6..0ff4e65 100644 --- a/Documentation/devicetree/bindings/mfd/s2mps11.txt +++ b/Documentation/devicetree/bindings/mfd/s2mps11.txt @@ -1,10 +1,10 @@ * Samsung S2MPS11 Voltage and Current Regulator -The Samsung S2MP211 is a multi-function device which includes voltage and +The Samsung S2MPS11 is a multi-function device which includes voltage and current regulators, RTC, charger controller and other sub-blocks. It is -interfaced to the host controller using a I2C interface. Each sub-block is -addressed by the host system using different I2C slave address. +interfaced to the host controller using an I2C interface. Each sub-block is +addressed by the host system using different I2C slave addresses. Required properties: - compatible: Should be "samsung,s2mps11-pmic". @@ -43,7 +43,8 @@ sub-node should be of the format as listed below. BUCK[2/3/4/6] supports disabling ramp delay on hardware, so explictly regulator-ramp-delay = <0> can be used for them to disable ramp delay. - In absence of regulator-ramp-delay property, default ramp delay will be used. + In the absence of regulator-ramp-delay property, default ramp delay will + be used. NOTE: Some BUCKs share the ramp rate setting i.e. same ramp value will be set for a particular group of BUCKs. So provide same regulator-ramp-delay<value>. -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
