Adding Shuah Khan<skhan@xxxxxxxxxxxxxxxxxxx> to cc. -Abhinav. On Wed, May 15, 2024 at 03:41:03AM +0000, Abhinav Saxena wrote: > Remove trailing whitespace from sound/hd-audio/notes as reported by > checkpatch. Removing trailing spaces improves consistency, and > prevents Preventing potential merge conflicts due to whitespace > differences. maintain a cleaner and more professional codebase. > > Signed-off-by: Abhinav Saxena <xandfury@xxxxxxxxx> > --- > Documentation/sound/hd-audio/notes.rst | 16 ++++++++-------- > 1 file changed, 8 insertions(+), 8 deletions(-) > > diff --git a/Documentation/sound/hd-audio/notes.rst b/Documentation/sound/hd-audio/notes.rst > index a9e35b1f87bd..ef6a4513cce7 100644 > --- a/Documentation/sound/hd-audio/notes.rst > +++ b/Documentation/sound/hd-audio/notes.rst > @@ -15,7 +15,7 @@ problem is broken BIOS, and the rest is the driver implementation. > This document explains the brief trouble-shooting and debugging > methods for the HD-audio hardware. > > -The HD-audio component consists of two parts: the controller chip and > +The HD-audio component consists of two parts: the controller chip and > the codec chips on the HD-audio bus. Linux provides a single driver > for all controllers, snd-hda-intel. Although the driver name contains > a word of a well-known hardware vendor, it's not specific to it but for > @@ -81,7 +81,7 @@ the wake-up timing. It wakes up a few samples before actually > processing the data on the buffer. This caused a lot of problems, for > example, with ALSA dmix or JACK. Since 2.6.27 kernel, the driver puts > an artificial delay to the wake up timing. This delay is controlled > -via ``bdl_pos_adj`` option. > +via ``bdl_pos_adj`` option. > > When ``bdl_pos_adj`` is a negative value (as default), it's assigned to > an appropriate value depending on the controller chip. For Intel > @@ -144,7 +144,7 @@ see a regression wrt the sound quality (stuttering, etc) or a lock-up > in the recent kernel, try to pass ``enable_msi=0`` option to disable > MSI. If it works, you can add the known bad device to the blacklist > defined in hda_intel.c. In such a case, please report and give the > -patch back to the upstream developer. > +patch back to the upstream developer. > > > HD-Audio Codec > @@ -375,7 +375,7 @@ HD-Audio Reconfiguration > ------------------------ > This is an experimental feature to allow you re-configure the HD-audio > codec dynamically without reloading the driver. The following sysfs > -files are available under each codec-hwdep device directory (e.g. > +files are available under each codec-hwdep device directory (e.g. > /sys/class/sound/hwC0D0): > > vendor_id > @@ -433,7 +433,7 @@ re-configure based on that state, run like below: > :: > > # echo 0x14 0x9993013f > /sys/class/sound/hwC0D0/user_pin_configs > - # echo 1 > /sys/class/sound/hwC0D0/reconfig > + # echo 1 > /sys/class/sound/hwC0D0/reconfig > > > Hint Strings > @@ -494,7 +494,7 @@ indep_hp (bool) > mixer control, if available > add_stereo_mix_input (bool) > add the stereo mix (analog-loopback mix) to the input mux if > - available > + available > add_jack_modes (bool) > add "xxx Jack Mode" enum controls to each I/O jack for allowing to > change the headphone amp and mic bias VREF capabilities > @@ -504,7 +504,7 @@ power_save_node (bool) > stream states > power_down_unused (bool) > power down the unused widgets, a subset of power_save_node, and > - will be dropped in future > + will be dropped in future > add_hp_mic (bool) > add the headphone to capture source if possible > hp_mic_detect (bool) > @@ -603,7 +603,7 @@ present. > > The patch module option is specific to each card instance, and you > need to give one file name for each instance, separated by commas. > -For example, if you have two cards, one for an on-board analog and one > +For example, if you have two cards, one for an on-board analog and one > for an HDMI video board, you may pass patch option like below: > :: > > -- > 2.34.1 >
