From: Srinivas Kandagatla <srinivas.kandagatla@xxxxxx> This patch attempts to collate generic bindings which can be used by the remote control hardwares. Currently the list is not long as there are only 2 drivers which are device tree'd. Mainly this patch tries to document few bindings used by ST IRB driver which can be generic as well. This document also add fews common bindings used by most of the drivers like, interrupts, regs, clocks and pinctrls. This document can also be holding place to describe generic bindings used in remote controls devices. Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxx> --- Hi All, Following Stephen Warren's suggestions at https://lkml.org/lkml/2013/9/24/452 this patch is an attempt to document such generic bindings in a common document. This document currently collates all the generic bindings used with remote-controls and act as holding place to describe generic bindings for remote controls. Comments? Thanks, srini .../devicetree/bindings/media/remote-control.txt | 31 ++++++++++++++++++++ 1 files changed, 31 insertions(+), 0 deletions(-) create mode 100644 Documentation/devicetree/bindings/media/remote-control.txt diff --git a/Documentation/devicetree/bindings/media/remote-control.txt b/Documentation/devicetree/bindings/media/remote-control.txt new file mode 100644 index 0000000..901ea56 --- /dev/null +++ b/Documentation/devicetree/bindings/media/remote-control.txt @@ -0,0 +1,31 @@ +Generic device tree bindings for remote control. + +properties: + - compatible: Can contain any remote control driver compatible string. + example: "st-comms-irb, "gpio-ir-receiver". + - reg: Base physical address of the controller and length of memory + mapped region. + - interrupts: Interrupt-specifier for the sole interrupt generated by + the device. The interrupt specifier format depends on the + interrupt controller parent. Iff the device supports interrupts. + - rx-mode: Can be "infrared" or "uhf". rx-mode should be present iff + the rx pins are wired up. + - tx-mode: Can be "infrared" or "uhf". tx-mode should be present iff + the tx pins are wired up. + +Optional properties: + - linux,rc-map-name: Linux specific remote control map name. Refer to + include/media/rc-map.h for full list of maps. + - pinctrl-names, pinctrl-0: The pincontrol settings to configure muxing + properly for the device pins. + - clocks : phandle with clock-specifier pair for the device specified + in compatible. + +example: + + rc: rc@fe518000 { + compatible = "st,comms-irb"; + reg = <0xfe518000 0x234>; + interrupts = <0 203 0>; + rx-mode = "infrared"; + }; -- 1.7.6.5 -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
