Re: [PATCH v6 3/3] w1: add UART w1 bus driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 13/02/2024 08:02, Christoph Winklhofer wrote:
> On Mon, Feb 12, 2024 at 04:30:00PM +0100, Krzysztof Kozlowski wrote:
>> On 09/02/2024 07:22, Christoph Winklhofer via B4 Relay wrote:
>>> From: Christoph Winklhofer <cj.winklhofer@xxxxxxxxx>
>>>
>>> Add a UART 1-Wire bus driver. The driver utilizes the UART interface via
>>> the Serial Device Bus to create the 1-Wire timing patterns. The driver
>>> was tested on a "Raspberry Pi 3B" with a DS18B20 and on a "Variscite
>>> DART-6UL" with a DS18S20 temperature sensor.
>>>
>>> The 1-Wire timing pattern and the corresponding UART baud-rate with the
>>> interpretation of the transferred bytes are described in the document:
>>
>>
>>> +/*
>>> + * struct w1_uart_config - configuration for 1-Wire operation
>>> + *
>>> + * @baudrate: baud-rate returned from serdev
>>> + * @delay_us: delay to complete a 1-Wire cycle (in us)
>>> + * @tx_byte: byte to generate 1-Wire timing pattern
>>> + */
>>> +struct w1_uart_config {
>>> +	unsigned int baudrate;
>>> +	unsigned int delay_us;
>>> +	u8 tx_byte;
>>> +};
>>> +
>>> +/*
>>> + * struct w1_uart_config - w1-uart device data
>>
>> That's neither correct (device, not config) nor proper kerneldoc nor
>> useful. Your comment repeats struct name. If you want to make it
>> kerneldoc, go ahead, but then make it a full kerneldoc.
>>
> 
> Yes, sorry - will use the correct name.
> 
>> And obviously compile with W=1.
>>
> 
> You mean the padding error of mutex, I get it with W=3 and will fix it
> by moving mutex up.

No, I meant W=1. Make it a kerneldoc and compile with W=1, so you will
see the warning.


Best regards,
Krzysztof





[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux