On 27/11/2023 05:32, Anshuman Khandual wrote:
>
>
> On 11/24/23 15:58, James Clark wrote:
>> FEAT_PMUv3_TH (Armv8.8) permits a PMU counter to increment only on
>> events whose count meets a specified threshold condition. For example if
>> PMEVTYPERn.TC (Threshold Control) is set to 0b101 (Greater than or
>> equal, count), and the threshold is set to 2, then the PMU counter will
>> now only increment by 1 when an event would have previously incremented
>> the PMU counter by 2 or more on a single processor cycle.
>>
>> Three new Perf event config fields, 'threshold', 'threshold_compare' and
>> 'threshold_count' have been added to control the feature.
>> threshold_compare maps to the upper two bits of PMEVTYPERn.TC and
>> threshold_count maps to the first bit of TC. These separate attributes
>> have been picked rather than enumerating all the possible combinations
>> of the TC field as in the Arm ARM. The attributes would be used on a
>> Perf command line like this:
>>
>> $ perf stat -e stall_slot/threshold=2,threshold_compare=2/
>>
>> A new capability for reading out the maximum supported threshold value
>> has also been added:
>>
>> $ cat /sys/bus/event_source/devices/armv8_pmuv3/caps/threshold_max
>>
>> 0x000000ff
>>
>> If a threshold higher than threshold_max is provided, then no error is
>> generated but the threshold is clamped to the max value. If
>> FEAT_PMUv3_TH isn't implemented or a 32 bit kernel is running, then
>> threshold_max reads zero, and neither the 'threshold' nor
>> 'threshold_control' parameters will be used.
>>
>> The threshold is per PMU counter, and there are potentially different
>> threshold_max values per PMU type on heterogeneous systems.
>>
>> Bits higher than 32 now need to be written into PMEVTYPER, so
>> armv8pmu_write_evtype() has to be updated to take an unsigned long value
>> rather than u32 which gives the correct behavior on both aarch32 and 64.
>>
>> Reviewed-by: Suzuki K Poulose <suzuki.poulose@xxxxxxx>
>> Signed-off-by: James Clark <james.clark@xxxxxxx>
>> ---
>> drivers/perf/arm_pmuv3.c | 84 +++++++++++++++++++++++++++++++++-
>> include/linux/perf/arm_pmuv3.h | 1 +
>> 2 files changed, 84 insertions(+), 1 deletion(-)
>>
>> diff --git a/drivers/perf/arm_pmuv3.c b/drivers/perf/arm_pmuv3.c
>> index 1d40d794f5e4..eb1ef84e1dbb 100644
>> --- a/drivers/perf/arm_pmuv3.c
>> +++ b/drivers/perf/arm_pmuv3.c
>> @@ -15,6 +15,7 @@
>> #include <clocksource/arm_arch_timer.h>
>>
>> #include <linux/acpi.h>
>> +#include <linux/bitfield.h>
>> #include <linux/clocksource.h>
>> #include <linux/of.h>
>> #include <linux/perf/arm_pmu.h>
>> @@ -294,9 +295,20 @@ static const struct attribute_group armv8_pmuv3_events_attr_group = {
>> .is_visible = armv8pmu_event_attr_is_visible,
>> };
>>
>> +#define THRESHOLD_LOW 2
>> +#define THRESHOLD_HIGH 13
>> +#define THRESHOLD_CNT 14
>> +#define THRESHOLD_CMP_LO 15
>> +#define THRESHOLD_CMP_HI 16
>> +
>> PMU_FORMAT_ATTR(event, "config:0-15");
>> PMU_FORMAT_ATTR(long, "config1:0");
>> PMU_FORMAT_ATTR(rdpmc, "config1:1");
>> +PMU_FORMAT_ATTR(threshold, "config1:" __stringify(THRESHOLD_LOW) "-"
>> + __stringify(THRESHOLD_HIGH));
>> +PMU_FORMAT_ATTR(threshold_compare, "config1:" __stringify(THRESHOLD_CMP_LO) "-"
>> + __stringify(THRESHOLD_CMP_HI));
>> +PMU_FORMAT_ATTR(threshold_count, "config1:" __stringify(THRESHOLD_CNT));
>
> Small nit - could this be formatted better ? Is not that the column could go
> upto 100 without setting off checkpatch.pl warning these days ?
I think it looks perfectly readable to me, is there a specific
formatting rule that's been broken? And no, it can't be unindented
without exceeding the 100 char limit.
>
>>
>> static int sysctl_perf_user_access __read_mostly;
>>
>> @@ -310,10 +322,33 @@ static inline bool armv8pmu_event_want_user_access(struct perf_event *event)
>> return event->attr.config1 & 0x2;
>> }
>>
>> +static inline u32 armv8pmu_event_threshold(struct perf_event_attr *attr)
>> +{
>> + return FIELD_GET(GENMASK(THRESHOLD_HIGH, THRESHOLD_LOW), attr->config1);
>> +}
>> +
>> +static inline u8 armv8pmu_event_threshold_control(struct perf_event_attr *attr)
>> +{
>> + u8 th_compare = FIELD_GET(GENMASK(THRESHOLD_CMP_HI, THRESHOLD_CMP_LO),
>> + attr->config1);
>
> Ditto
>
There's no rule saying that you can't indent _before_ 100 chars. Most of
the code in this file is indented at 80 chars, and consistency is
usually valued above other things.
>> + u8 th_count = FIELD_GET(BIT(THRESHOLD_CNT), attr->config1);
>> +
>> + /*
>> + * The count bit is always the bottom bit of the full control field, and
>> + * the comparison is the upper two bits, but it's not explicitly
>> + * labelled in the Arm ARM. For the Perf interface we split it into two
>> + * fields, so reconstruct it here.
>> + */
>> + return (th_compare << 1) | th_count;
>> +}
>> +
>> static struct attribute *armv8_pmuv3_format_attrs[] = {
>> &format_attr_event.attr,
>> &format_attr_long.attr,
>> &format_attr_rdpmc.attr,
>> + &format_attr_threshold.attr,
>> + &format_attr_threshold_compare.attr,
>> + &format_attr_threshold_count.attr,
>> NULL,
>> };
>>
>> @@ -365,10 +400,38 @@ static ssize_t bus_width_show(struct device *dev, struct device_attribute *attr,
>>
>> static DEVICE_ATTR_RO(bus_width);
>>
>> +static u32 threshold_max(struct arm_pmu *cpu_pmu)
>> +{
>> + /*
>> + * PMMIR.THWIDTH is readable and non-zero on aarch32, but it would be
>> + * impossible to write the threshold in the upper 32 bits of PMEVTYPER.
>> + */
>> + if (IS_ENABLED(CONFIG_ARM))
>> + return 0;
>> +
>> + /*
>> + * The largest value that can be written to PMEVTYPER<n>_EL0.TH is
>> + * (2 ^ PMMIR.THWIDTH) - 1.
>> + */
>> + return (1 << FIELD_GET(ARMV8_PMU_THWIDTH, cpu_pmu->reg_pmmir)) - 1;
>> +}
>> +
>> +static ssize_t threshold_max_show(struct device *dev,
>> + struct device_attribute *attr, char *page)
>> +{
>> + struct pmu *pmu = dev_get_drvdata(dev);
>> + struct arm_pmu *cpu_pmu = container_of(pmu, struct arm_pmu, pmu);
>> +
>> + return sysfs_emit(page, "0x%08x\n", threshold_max(cpu_pmu));
>> +}
>> +
>> +static DEVICE_ATTR_RO(threshold_max);
>> +
>> static struct attribute *armv8_pmuv3_caps_attrs[] = {
>> &dev_attr_slots.attr,
>> &dev_attr_bus_slots.attr,
>> &dev_attr_bus_width.attr,
>> + &dev_attr_threshold_max.attr,
>> NULL,
>> };
>>
>> @@ -552,7 +615,7 @@ static void armv8pmu_write_counter(struct perf_event *event, u64 value)
>> armv8pmu_write_hw_counter(event, value);
>> }
>>
>> -static inline void armv8pmu_write_evtype(int idx, u32 val)
>> +static inline void armv8pmu_write_evtype(int idx, unsigned long val)
>> {
>> u32 counter = ARMV8_IDX_TO_COUNTER(idx);
>> unsigned long mask = ARMV8_PMU_EVTYPE_EVENT |
>> @@ -921,6 +984,10 @@ static int armv8pmu_set_event_filter(struct hw_perf_event *event,
>> struct perf_event_attr *attr)
>> {
>> unsigned long config_base = 0;
>> + struct perf_event *perf_event = container_of(attr, struct perf_event,
>> + attr);
>
> Ditto
>
>> + struct arm_pmu *cpu_pmu = to_arm_pmu(perf_event->pmu);
>> + u32 th, th_max;
>>
>> if (attr->exclude_idle)
>> return -EPERM;
>> @@ -952,6 +1019,21 @@ static int armv8pmu_set_event_filter(struct hw_perf_event *event,
>> if (attr->exclude_user)
>> config_base |= ARMV8_PMU_EXCLUDE_EL0;
>>
>> + /*
>> + * Insert event counting threshold (FEAT_PMUv3_TH) values. If
>> + * FEAT_PMUv3_TH isn't implemented, then THWIDTH (threshold_max) will be
>> + * 0 and no values will be written.
>> + */
>> + th_max = threshold_max(cpu_pmu);
>> + if (IS_ENABLED(CONFIG_ARM64) && th_max) {
>> + th = min(armv8pmu_event_threshold(attr), th_max);
>> + if (th) {
>> + config_base |= FIELD_PREP(ARMV8_PMU_EVTYPE_TH, th);
>> + config_base |= FIELD_PREP(ARMV8_PMU_EVTYPE_TC,
>> + armv8pmu_event_threshold_control(attr));
>
> Ditto. As mentioned earlier this could have been avoided using a local variable.
>
But explained why it's like that on the previous review. It's completely
down to personal preference whether a local variable is used or not. I
don't see why this is a review comment, it doesn't affect how the code
behaves or the readability in any way.
And what could be avoided? No formatting rules have been broken.
>> + }
>> + }
>> +
>> /*
>> * Install the filter into config_base as this is used to
>> * construct the event type.
>> diff --git a/include/linux/perf/arm_pmuv3.h b/include/linux/perf/arm_pmuv3.h
>> index ddd1fec86739..ccbc0f9a74d8 100644
>> --- a/include/linux/perf/arm_pmuv3.h
>> +++ b/include/linux/perf/arm_pmuv3.h
>> @@ -258,6 +258,7 @@
>> #define ARMV8_PMU_BUS_SLOTS_MASK 0xff
>> #define ARMV8_PMU_BUS_WIDTH_SHIFT 16
>> #define ARMV8_PMU_BUS_WIDTH_MASK 0xf
>> +#define ARMV8_PMU_THWIDTH GENMASK(23, 20)
>>
>> /*
>> * This code is really good
>
> Otherwise LGTM
>
> Reviewed-by: Anshuman Khandual <anshuman.khandual@xxxxxxx>
>
