With Sub-NUMA Cluster mode enabled the scope of monitoring resources is per-NODE instead of per-L3 cache. Suffixes of directories with "L3" in their name refer to Sub-NUMA nodes instead of L3 cache ids. Users should be aware that SNC mode also affects the amount of L3 cache available for allocation within each SNC node. Reviewed-by: Peter Newman <peternewman@xxxxxxxxxx> Signed-off-by: Tony Luck <tony.luck@xxxxxxxxx> --- Documentation/arch/x86/resctrl.rst | 23 ++++++++++++++++++++--- 1 file changed, 20 insertions(+), 3 deletions(-) diff --git a/Documentation/arch/x86/resctrl.rst b/Documentation/arch/x86/resctrl.rst index a6279df64a9d..d1db200db5f9 100644 --- a/Documentation/arch/x86/resctrl.rst +++ b/Documentation/arch/x86/resctrl.rst @@ -366,9 +366,9 @@ When control is enabled all CTRL_MON groups will also contain: When monitoring is enabled all MON groups will also contain: "mon_data": - This contains a set of files organized by L3 domain and by - RDT event. E.g. on a system with two L3 domains there will - be subdirectories "mon_L3_00" and "mon_L3_01". Each of these + This contains a set of files organized by L3 domain or by NUMA + node (depending on whether Sub-NUMA Cluster (SNC) mode is disabled + or enabled respectively) and by RDT event. Each of these directories have one file per event (e.g. "llc_occupancy", "mbm_total_bytes", and "mbm_local_bytes"). In a MON group these files provide a read out of the current value of the event for @@ -478,6 +478,23 @@ if non-contiguous 1s value is supported. On a system with a 20-bit mask each bit represents 5% of the capacity of the cache. You could partition the cache into four equal parts with masks: 0x1f, 0x3e0, 0x7c00, 0xf8000. +Notes on Sub-NUMA Cluster mode +============================== +When SNC mode is enabled Linux may load balance tasks between Sub-NUMA +nodes much more readily than between regular NUMA nodes since the CPUs +on Sub-NUMA nodes share the same L3 cache and the system may report +the NUMA distance between Sub-NUMA nodes with a lower value than used +for regular NUMA nodes. Users who do not bind tasks to the CPUs of a +specific Sub-NUMA node must read the "llc_occupancy", "mbm_total_bytes", +and "mbm_local_bytes" for all Sub-NUMA nodes where the tasks may execute +to get the full view of traffic for which the tasks were the source. + +The cache allocation feature still provides the same number of +bits in a mask to control allocation into the L3 cache. But each +of those ways has its capacity reduced because the cache is divided +between the SNC nodes. The values reported in the resctrl +"size" files are adjusted accordingly. + Memory bandwidth Allocation and monitoring ========================================== -- 2.41.0
