> I understand that you are using two LAN8650, isn't it? if so are they > both running simultaneously? or you are doing the testing with one alone? Currently we've only got one running, hopefully we've wrapped up the board bring up in the next few days and will be able to run the second mac/phy as well. > > With this setup I'm getting a maximum throughput of about 90kB/s. > > If I increase the chunk size / oa-cps to 64 I get a might higher > > throughput ~900kB/s, but after 0-2s I get dump below (or similar). > Did you or possible to try a test case with below configuration? > > - Single LAN8650 enabled > - UDP > - oa_cps = 64 > - spi-max-frequency = 15000000, I'll set that up and will get back to you, all testing I have performed has been with tcp. > > Did you run iperf3 test? or any other tool? > If iperf3 then can you share the configuration you used? I just tried copying a file over the network with rsync, but I'll run some udp tests with iperf. I'll do my best to get back to you with results today. > > I don't know whether these may audiences are needed in the CC for this > thread. Let's see what's Andrew Lunn thinks about it? No opinions on my end at least. BR Ramón
