Add support of the device tree probing for the Renesas SH-Mobile SoCs.
This work is loosely based on an original patch by Nobuhiro Iwamatsu
<nobuhiro.iwamatsu.yj@xxxxxxxxxxx>.
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@xxxxxxxxxxxxxxxxxx>
---
This patch is against Dave's 'net-next.git' repo.
Documentation/devicetree/bindings/net/sh_eth.txt | 40 +++++++++++++
drivers/net/ethernet/renesas/sh_eth.c | 66 ++++++++++++++++++++++-
2 files changed, 105 insertions(+), 1 deletion(-)
Index: net-next/Documentation/devicetree/bindings/net/sh_eth.txt
===================================================================
--- /dev/null
+++ net-next/Documentation/devicetree/bindings/net/sh_eth.txt
@@ -0,0 +1,40 @@
+* Renesas Electronics SH EtherMAC
+
+This file provides information on what the device node for the SH EtherMAC
+interface contains.
+
+Required properties:
+- compatible: "renesas,gether-r8a7740" if the device is a part of R8A7740 SoC.
+ "renesas,ether-r8a7779" if the device is a part of R8A7778/9 SoCs.
+ "renesas,ether-r8a7790" if the device is a part of R8A7790/1 SoCs.
+- reg: offset and length of the register set for the device; if the device has
+ TSU registers, you need to specify two register sets here.
+- interrupt-parent: the phandle for the interrupt controller that services
+ interrupts for this device.
+- interrupts: interrupt mapping for the interrupt source.
+- phy-mode: string, operation mode of the PHY interface (a string that
+ of_get_phy_mode() can understand).
+- phy-handle: phandle of the PHY device.
+
+Optional properties:
+- local-mac-address: 6 bytes, MAC address.
+- renesas,no-ether-link: specify when a board does not provide a proper LINK
+ signal.
+- renesas,ether-link-active-low: specify when the LINK signal is active-low.
+
+Example (Armadillo800EVA board):
+
+ ethernet@e9a00000 {
+ compatible = "renesas,gether-r8a7740";
+ reg = <0xe9a00000 0x800>, <0xe9a01800 0x800>;
+ interrupt-parent = <&gic>;
+ interrupts = <0 142 0x4>;
+ phy-mode = "mii";
+ phy-handle = <&phy0>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ phy0: ethernet-phy@0 {
+ reg = <0>;
+ };
+ };
Index: net-next/drivers/net/ethernet/renesas/sh_eth.c
===================================================================
--- net-next.orig/drivers/net/ethernet/renesas/sh_eth.c
+++ net-next/drivers/net/ethernet/renesas/sh_eth.c
@@ -32,6 +32,9 @@
#include <linux/platform_device.h>
#include <linux/mdio-bitbang.h>
#include <linux/netdevice.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
+#include <linux/of_net.h>
#include <linux/phy.h>
#include <linux/cache.h>
#include <linux/io.h>
@@ -2600,6 +2603,52 @@ static const struct net_device_ops sh_et
.ndo_change_mtu = eth_change_mtu,
};
+#ifdef CONFIG_OF
+static struct sh_eth_plat_data *sh_eth_parse_dt(struct device *dev)
+{
+ struct device_node *np = dev->of_node;
+ struct sh_eth_plat_data *pdata;
+ struct device_node *phy;
+ const char *mac_addr;
+
+ pdata = devm_kzalloc(dev, sizeof(*pdata), GFP_KERNEL);
+ if (!pdata)
+ return NULL;
+
+ pdata->phy_interface = of_get_phy_mode(np);
+
+ phy = of_parse_phandle(np, "phy-handle", 0);
+ if (!phy || of_property_read_u32(phy, "reg", &pdata->phy)) {
+ devm_kfree(dev, pdata);
+ return NULL;
+ }
+
+ mac_addr = of_get_mac_address(np);
+ if (mac_addr)
+ memcpy(pdata->mac_addr, mac_addr, ETH_ALEN);
+
+ pdata->no_ether_link =
+ of_property_read_bool(np, "renesas,no-ether-link");
+ pdata->ether_link_active_low =
+ of_property_read_bool(np, "renesas,ether-link-active-low");
+
+ return pdata;
+}
+
+static const struct of_device_id sh_eth_match_table[] = {
+ { .compatible = "renesas,gether-r8a7740", .data = &r8a7740_data },
+ { .compatible = "renesas,ether-r8a7779", .data = &r8a777x_data },
+ { .compatible = "renesas,ether-r8a7790", .data = &r8a7790_data },
+ { }
+};
+MODULE_DEVICE_TABLE(of, sh_eth_match_table);
+#else
+static inline struct sh_eth_plat_data *sh_eth_parse_dt(struct device *dev)
+{
+ return NULL;
+}
+#endif
+
static int sh_eth_drv_probe(struct platform_device *pdev)
{
int ret, devno = 0;
@@ -2653,6 +2702,8 @@ static int sh_eth_drv_probe(struct platf
pm_runtime_enable(&pdev->dev);
pm_runtime_resume(&pdev->dev);
+ if (pdev->dev.of_node)
+ pd = sh_eth_parse_dt(&pdev->dev);
if (!pd) {
dev_err(&pdev->dev, "no platform data\n");
ret = -EINVAL;
@@ -2668,7 +2719,19 @@ static int sh_eth_drv_probe(struct platf
mdp->ether_link_active_low = pd->ether_link_active_low;
/* set cpu data */
- mdp->cd = (struct sh_eth_cpu_data *)id->driver_data;
+ if (id) {
+ mdp->cd = (struct sh_eth_cpu_data *)id->driver_data;
+ } else {
+ const struct of_device_id *match;
+
+ match = of_match_device(of_match_ptr(sh_eth_match_table),
+ &pdev->dev);
+ if (!match) {
+ ret = -EINVAL;
+ goto out_release;
+ }
+ mdp->cd = (struct sh_eth_cpu_data *)match->data;
+ }
mdp->reg_offset = sh_eth_get_register_offset(mdp->cd->register_type);
sh_eth_set_default_cpu_data(mdp->cd);
@@ -2809,6 +2872,7 @@ static struct platform_driver sh_eth_dri
.driver = {
.name = CARDNAME,
.pm = SH_ETH_PM_OPS,
+ .of_match_table = of_match_ptr(sh_eth_match_table),
},
};
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
