[ Resend - rejected by netdev and linux-doc MLs for HTML content] On 2023-10-10 14:40, Willem de Bruijn wrote:
On Tue, Oct 10, 2023 at 4:05 PM Ahmed Zaki <ahmed.zaki@xxxxxxxxx> wrote:Symmetric RSS hash functions are beneficial in applications that monitor both Tx and Rx packets of the same flow (IDS, software firewalls, ..etc). Getting all traffic of the same flow on the same RX queue results in higher CPU cache efficiency. A NIC that supports "symmetric-xor" can achieve this RSS hash symmetry by XORing the source and destination fields and pass the values to the RSS hash algorithm. Only fields that has counterparts in the other direction can be accepted; IP src/dst and L4 src/dst ports. The user may request RSS hash symmetry for a specific flow type, via: # ethtool -N|-U eth0 rx-flow-hash <flow_type> s|d|f|n symmetric-xor or turn symmetry off (asymmetric) by: # ethtool -N|-U eth0 rx-flow-hash <flow_type> s|d|f|n Reviewed-by: Wojciech Drewek <wojciech.drewek@xxxxxxxxx> Signed-off-by: Ahmed Zaki <ahmed.zaki@xxxxxxxxx> --- Documentation/networking/scaling.rst | 6 ++++++ include/uapi/linux/ethtool.h | 17 +++++++++-------- net/ethtool/ioctl.c | 11 +++++++++++ 3 files changed, 26 insertions(+), 8 deletions(-) diff --git a/Documentation/networking/scaling.rst b/Documentation/networking/scaling.rst index 92c9fb46d6a2..64f3d7566407 100644 --- a/Documentation/networking/scaling.rst +++ b/Documentation/networking/scaling.rst @@ -44,6 +44,12 @@ by masking out the low order seven bits of the computed hash for the packet (usually a Toeplitz hash), taking this number as a key into the indirection table and reading the corresponding value. +Some NICs support symmetric RSS hashing where, if the IP (source address, +destination address) and TCP/UDP (source port, destination port) tuples +are swapped, the computed hash is the same. This is beneficial in some +applications that monitor TCP/IP flows (IDS, firewalls, ...etc) and need +both directions of the flow to land on the same Rx queue (and CPU). +Maybe add a short ethtool example?
Same example as in commit message is OK?AFAIK, the "ethtool" patch has to be sent after this series is accepted. So I am not 100% sure of how the ethtool side will look like, but I can add the line above to Doc.
Some advanced NICs allow steering packets to queues based on programmable filters. For example, webserver bound TCP port 80 packets can be directed to their own receive queue. Such “n-tuple” filters can diff --git a/include/uapi/linux/ethtool.h b/include/uapi/linux/ethtool.h index f7fba0dc87e5..b9ee667ad7e5 100644 --- a/include/uapi/linux/ethtool.h +++ b/include/uapi/linux/ethtool.h @@ -2018,14 +2018,15 @@ static inline int ethtool_validate_duplex(__u8 duplex) #define FLOW_RSS 0x20000000 /* L3-L4 network traffic flow hash options */ -#define RXH_L2DA (1 << 1) -#define RXH_VLAN (1 << 2) -#define RXH_L3_PROTO (1 << 3) -#define RXH_IP_SRC (1 << 4) -#define RXH_IP_DST (1 << 5) -#define RXH_L4_B_0_1 (1 << 6) /* src port in case of TCP/UDP/SCTP */ -#define RXH_L4_B_2_3 (1 << 7) /* dst port in case of TCP/UDP/SCTP */ -#define RXH_DISCARD (1 << 31) +#define RXH_L2DA (1 << 1) +#define RXH_VLAN (1 << 2) +#define RXH_L3_PROTO (1 << 3) +#define RXH_IP_SRC (1 << 4) +#define RXH_IP_DST (1 << 5) +#define RXH_L4_B_0_1 (1 << 6) /* src port in case of TCP/UDP/SCTP */ +#define RXH_L4_B_2_3 (1 << 7) /* dst port in case of TCP/UDP/SCTP */ +#define RXH_SYMMETRIC_XOR (1 << 30) +#define RXH_DISCARD (1 << 31)Are these indentation changes intentional?
Yes, for alignment ("RXH_SYMMETRIC_XOR" is too long).
