Document new Hardware driven LEDs APIs. Some LEDs can be programmed to be entirely driven by hw. This is not limited to blink but also to turn off or on autonomously. To support this feature, a LED needs to implement various additional ops and needs to declare specific support for the supported triggers. Add documentation for each required value and API to make hw control possible and implementable by both LEDs and triggers. Signed-off-by: Christian Marangi <ansuelsmth@xxxxxxxxx> --- Documentation/leds/leds-class.rst | 56 +++++++++++++++++++++++++++++++ 1 file changed, 56 insertions(+) diff --git a/Documentation/leds/leds-class.rst b/Documentation/leds/leds-class.rst index cd155ead8703..a7bc31e9b919 100644 --- a/Documentation/leds/leds-class.rst +++ b/Documentation/leds/leds-class.rst @@ -169,6 +169,62 @@ Setting the brightness to zero with brightness_set() callback function should completely turn off the LED and cancel the previously programmed hardware blinking function, if any. +Hardware driven LEDs +==================== + +Some LEDs can be programmed to be entirely driven by hw. This is not +limited to blink but also to turn off or on autonomously. +To support this feature, a LED needs to implement various additional +ops and needs to declare specific support for the supported triggers. + +With hw control we refer to the LED driven by hardware. + +LED driver must define the following value to support hw control: + + - hw_control_trigger: + unique trigger name supported by the LED in hw control + mode. + + - trigger_supported_flags_mask: + mask of the different supported trigger mode for the + defined trigger in hw control mode. + +LED driver must implement the following API to support hw control: + + - hw_control_set: + activate hw control, LED driver will use the provided + flags passed from the supported trigger, parse them to + a set of mode and setup the LED to be driven by hardware + following the requested modes. + + Set LED_OFF via the brightness_set to deactivate hw control. + + - hw_control_get: + get from a LED already in hw control, the active modes, + parse them and set in flags the current active flags for + the supported trigger. + + - hw_control_is_supported: + check if the flags passed by the supported trigger can + be parsed and activate hw control on the LED. + +LED driver can activate additional modes by default to workaround the +impossibility of supporting each different mode on the supported trigger. +Example are hardcoding the blink speed to a set interval, enable special +feature like bypassing blink if some requirements are not met. + +A helper led_trigger_can_hw_control() is provided to check if the LED +can actually run in hw control. + +A trigger should first use such helper to verify if hw control is possible, +use hw_control_is_supported to check if the flags are supported and only at +the end use hw_control_set to activate hw control. + +A trigger can use hw_control_get to check if a LED is already in hw control +and init their flags. + +When the LED is in hw control, no software blink is possible and doing so +will effectively disable hw control. Known Issues ============ -- 2.39.2
