Hi Bagas,
On 3/27/2023 5:06 PM, Bagas Sanjaya wrote:
On Fri, Mar 24, 2023 at 02:16:08PM +0800, Hao Zhang wrote:
+Sysfs files and directories
+---------------------------
+
+Root: ``/sys/bus/coresight/devices/dummy<N>``
+
+----
+
+:File: ``enable_source`` (RW)
+:Notes:
+ - > 0 : enable the datasets of dummy source.
+
+ - = 0 : disable the datasets of dummy source.
+
+:Syntax:
+ ``echo 1 > enable_source``
+
+----
+
+:File: ``enable_sink`` (RW)
+:Notes:
+ - > 0 : enable the datasets of dummy sink.
+
+ - = 0 : disable the datasets of dummy sink.
+
+:Syntax:
+ ``echo 1 > enable_sink``
Is enable_{source,sink} integer-valued or bit (0/1)? In other words, is
it OK to `echo 2` to both sysfs files?
It should be the integer value, that is OK to "echo 2" to the sysfs files.
+
+----
+
+Config details
+---------------------------
+
+There are two types of nodes, dummy sink and dummy source. The nodes
+should be observed at the coresight path
+"/sys/bus/coresight/devices".
For consistency, inline this sysfs also (thus
``/sys/bus/coresight/devices``.
+e.g.
e.g.:: (make the shell snippet below code block)
I will correct it in the next version of patch.
+/sys/bus/coresight/devices # ls -l | grep dummy
IMO I prefer `PS1=\$` (that is, omit the directory). Alternatively,
you can write `ls -l /sys/bus/coresight/devices | grep dummy` (specify
the directory to `ls`).
Thanks.
Thanks for your comments, I will take your advice in the next version of
patch.
Thanks,
Hao
