Re: [PATCH v9 14/27] gunyah: vm_mgr: Add ioctls to support basic non-proxy VM boot

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 1/30/2023 12:53 AM, Srivatsa Vaddagiri wrote:
* Elliot Berman <quic_eberman@xxxxxxxxxxx> [2023-01-20 14:46:13]:

+static int gh_vm_start(struct gunyah_vm *ghvm)
+{
+	struct gunyah_vm_memory_mapping *mapping;
+	u64 dtb_offset;
+	u32 mem_handle;
+	int ret;
+
+	down_write(&ghvm->status_lock);
+	if (ghvm->vm_status != GH_RM_VM_STATUS_NO_STATE) {
+		up_write(&ghvm->status_lock);
+		return 0;

return -EINVAL in this case.

Additionally check if its already GH_RM_VM_STATUS_READY and return 0 in that
case.

[snip]


Caller can use gh_vm_ensure_started for this behavior. I'll move this to be used in the GH_VM_RUN ioctl as well.


+	mem_handle = mapping->parcel.mem_handle;
+	dtb_offset = ghvm->dtb_config.gpa - mapping->guest_phys_addr;
+
+	ret = gh_rm_vm_configure(ghvm->rm, ghvm->vmid, ghvm->auth, mem_handle,
+				0, 0, dtb_offset, ghvm->dtb_config.size);

Default value of auth is 0 (GH_RM_VM_AUTH_NONE). Is that what you wanted here?
Perhaps initialize default value of auth to be GH_RM_VM_AUTH_QCOM_PIL_ELF?


Yes, default VM is GH_RM_VM_AUTH_NONE.



[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux