This display the following code extract as a code block instead of a normal paragraph. Signed-off-by: Yoann Congal <yoann.congal@xxxxxxxx> --- Documentation/trace/kprobetrace.rst | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Documentation/trace/kprobetrace.rst b/Documentation/trace/kprobetrace.rst index 5c49cdc8f8323..febfd3792854f 100644 --- a/Documentation/trace/kprobetrace.rst +++ b/Documentation/trace/kprobetrace.rst @@ -161,11 +161,11 @@ You can add and enable new kprobe events when booting up the kernel by "kprobe_event=" parameter. The parameter accepts a semicolon-delimited kprobe events, which format is similar to the kprobe_events. The difference is that the probe definition parameters are comma-delimited -instead of space. For example, adding myprobe event on do_sys_open like below +instead of space. For example, adding myprobe event on do_sys_open like below:: p:myprobe do_sys_open dfd=%ax filename=%dx flags=%cx mode=+4($stack) -should be below for kernel boot parameter (just replace spaces with comma) +should be below for kernel boot parameter (just replace spaces with comma):: p:myprobe,do_sys_open,dfd=%ax,filename=%dx,flags=%cx,mode=+4($stack) -- 2.30.2
