On Wed, Dec 21, 2022 at 09:54:43AM +0000, Russell King (Oracle) wrote: > On Wed, Dec 21, 2022 at 12:59:55AM +0100, Andrew Lunn wrote: > > > > One thought on this approach though - if one has a PHY that supports > > > > "activity" but not independent "rx" and "tx" activity indications > > > > and it doesn't support software control, how would one enable activity > > > > mode? There isn't a way to simultaneously enable both at the same > > > > time... However, I need to check whether there are any PHYs that fall > > > > into this category. > > > > > > > > > > Problem is that for such feature and to have at least something working > > > we need to face compromise. We really can't support each switch feature > > > and have a generic API for everything. > > > > I agree we need to make compromises. We cannot support every LED > > feature of every PHY, they are simply too diverse. Hopefully we can > > support some features of every PHY. In the worst case, a PHY simply > > cannot be controlled via this method, which is the current state > > today. So it is not worse off. > > ... and that compromise is that it's not going to be possible to enable > activity mode on 88e151x with how the code stands and with the > independent nature of "rx" and "tx" activity control currently in the > netdev trigger... making this whole approach somewhat useless for > Marvell PHYs. Again we can consider adding an activity mode. It seems logical that some switch may only support global traffic instead of independend tx or rx... The feature are not mutually exclusive. One include the other 2. We already a simple workaround for the link mode where on the current driver, if the link mode is enabled just all rule for 10 100 and 1000 mbps are enabled simulating a global link event. > > We really need to see a working implementation for this code for more > than just one PHY to prove that it is actually possible for it to > support other PHYs. If not, it isn't actually solving the problem, > and we're going to continue getting custom implementations to configure > the LED settings. > Agree that we need other user for this to catch some problem in the implementation of this generic API. -- Ansuel
