On Mon, Dec 05, 2022 at 09:43:32AM +0800, Kent Gibson wrote: > On Sat, Dec 03, 2022 at 10:38:45AM +0100, Linus Walleij wrote: > > On Wed, Nov 30, 2022 at 4:55 PM Andy Shevchenko > > <andriy.shevchenko@xxxxxxxxxxxxxxx> wrote: > > > > > +The below table gathered the most used cases. > > > + > > > +========== ========== =============== ======================= > > > + Input Output State What value to return? > > > +========== ========== =============== ======================= > > > + Disabled Disabled Hi-Z input buffer > > > + Disabled OS/OD/etc Single ended [cached] output buffer > > > + x Push-Pull Out [cached] output buffer > > > + Enabled Disabled In input buffer > > > + Enabled OS/OD/etc Bidirectional input buffer > > > +========== ========== =============== ======================= > > > > This looks about right to me, but we need more input, Kent? > > > > Firstly, I'm all for tightening up the driver contract, and hope that > whatever is decided will also be updated in driver.h itself. > > I can also understand Andy wanting to add support for Bidirectional > using the existing API. > > But, and please correct me if I'm wrong, the user has no control over > whether an open drain output is single ended or bidirectional, and > no visibility as to which the driver supports or chooses. > So the contract is still vague. > > My preference would be for the driver API to be extended with a new > callback for the output buffer, say get_output(), and have the existing > get() always return the input buffer. Both would return an error if the > buffer is unavailable or disconnected, e.g. in the Hi-Z case. > As per Hans' suggestions, this would keep the drivers simple. That's not about keeping driver simple, it's about how from hardware (electrical) point of view we should recognize the GPIO signal value. And I disagree on the input buffer to be always involved (in particular, not all hardware may support that anyway). That said, I will send an answer to all you guys, but just to make sure that we are on the different pages here I state yet another time that this is not about solely software p.o.v. And yes, there is no simple answer to the question. > Then cdev could determine the approriate buffer to return, depending > on the mode. Or, better yet, we extend that through the uAPI and > handball that decision to the user. TL;DR: I don't like this idea. -- With Best Regards, Andy Shevchenko
