Re: [RFC PATCH v6 09/11] leds: trigger: netdev: add additional hardware only triggers

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, May 03, 2022 at 05:16:31PM +0200, Ansuel Smith wrote:
> Add additional hardware only triggers commonly supported by switch LEDs.
> 
> Additional modes:
> link_10: LED on with link up AND speed 10mbps
> link_100: LED on with link up AND speed 100mbps
> link_1000: LED on with link up AND speed 1000mbps
> half_duplex: LED on with link up AND half_duplex mode
> full_duplex: LED on with link up AND full duplex mode
> 
> Additional blink interval modes:
> blink_2hz: LED blink on any even at 2Hz (250ms)
> blink_4hz: LED blink on any even at 4Hz (125ms)
> blink_8hz: LED blink on any even at 8Hz (62ms)

I would suggest separating blink intervals into a patch of their own,
because they are orthogonal to the other modes. Most PHYs are not
going to support them, or they have to be the same across all LEDs, or
don't for example make sense with duplex etc. We need to first
concentrate on the basics, get that correct. Then we can add nice to
have features like this.

     Andrew



[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux