Hello, This patch series is a porposal to enhance the sam9 watchdog timer support. The at91sam9 watchdog timer cannot configured twice, and the current implementation only tries to configure in a static way: - 2 seconds timeout - wdt restart every 500ms If the timer has already been configured with different values, it returns an error and do not create any watchdog device. This is not critical if the watchdog is disabled, but if it has been enabled with different timeout values it will lead to a SoC reset. This patch series tries to address this issue by adapting the heartbeat value according the WDT timer config: - it first tries to configure the timer as requested. - if it fails it fallbacks to the current config, adapting its heartbeat timer to the needs This patch series also move to a dynamically allocated at91wdt device instead of the static instance. I'm not sure this is the best solution, so please tell me if you prefer to keep static instance of watchdog. It adds a new at91 wdt type: software. This new type make use of the at91 wdt interrupt to trigger a software watchdog. Finally it adds several properties to the device tree bindings. Best Regards, Boris Boris BREZILLON (4): watchdog: at91sam9_wdt: better watchdog support watchdog: at91sam9_wdt: update device tree doc ARM: at91/dt: add sam9 watchdog default options to SoCs ARM: at91/dt: add watchdog properties to kizbox board .../devicetree/bindings/watchdog/atmel-wdt.txt | 30 +- arch/arm/boot/dts/at91sam9260.dtsi | 5 + arch/arm/boot/dts/at91sam9263.dtsi | 5 + arch/arm/boot/dts/at91sam9g45.dtsi | 5 + arch/arm/boot/dts/at91sam9n12.dtsi | 5 + arch/arm/boot/dts/at91sam9x5.dtsi | 5 + arch/arm/boot/dts/kizbox.dts | 6 + arch/arm/boot/dts/sama5d3.dtsi | 5 + drivers/watchdog/at91sam9_wdt.c | 319 +++++++++++++++----- 9 files changed, 300 insertions(+), 85 deletions(-) -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html