Re: [PATCH v3 6/7] ARM: kirkwood: add gigabit ethernet and mvmdio device tree nodes

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 05/20/2013 11:27 PM, Simon Baatz wrote:
Hi Sebastian,

On Mon, May 06, 2013 at 05:33:39PM +0200, Sebastian Hesselbarth wrote:
This patch adds mv643xx_eth and mvmdio device tree nodes for DT enabled
Kirkwood boards. Phy nodes are also added with reg property set on a
per-board basis.
...
diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi
index fada7e6..c01a273 100644
--- a/arch/arm/boot/dts/kirkwood.dtsi
+++ b/arch/arm/boot/dts/kirkwood.dtsi
@@ -202,5 +202,57 @@
  			clocks =<&gate_clk 4>;
  			status = "disabled";
  		};
+
+		mdio: mdio-bus@72004 {
+			compatible = "marvell,orion-mdio";
+			reg =<0x72004 0x84>;
+			interrupts =<11>;

Shouldn't this be 46?

Yes, mdio is using GbE0Err interrupt and that is 14 on IRQ HIGH CAUSE.
I was misled by 11 on IRQ LOW CAUSE.

Sebastian
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux