Since 89a6a5e56c82("regulator: add property parsing and callbacks to set protection limits")
which introduced a warning:
Documentation/driver-api/regulator:166: ./include/linux/regulator/driver.h:96: WARNING: Unexpected indentation.
Documentation/driver-api/regulator:166: ./include/linux/regulator/driver.h:98: WARNING: Block quote ends without a blank line; unexpected unindent.
Let's fix them.
Signed-off-by: Yanteng Si <siyanteng@xxxxxxxxxxx>
---
v2:
* Add blankline.
* a text Block which should begins with a "-", followd by whitespace.
v1:
* regulato: remove unnecessary indentation from driver.h's comments
include/linux/regulator/driver.h | 22 +++++++++++++---------
1 file changed, 13 insertions(+), 9 deletions(-)
diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h
index 66219b174a8a..0228caaa6741 100644
--- a/include/linux/regulator/driver.h
+++ b/include/linux/regulator/driver.h
@@ -90,15 +90,19 @@ enum regulator_detection_severity {
* @set_over_current_protection: Support enabling of and setting limits for over
* current situation detection. Detection can be configured for three
* levels of severity.
- * REGULATOR_SEVERITY_PROT should automatically shut down the regulator(s).
- * REGULATOR_SEVERITY_ERR should indicate that over-current situation is
- * caused by an unrecoverable error but HW does not perform
- * automatic shut down.
- * REGULATOR_SEVERITY_WARN should indicate situation where hardware is
- * still believed to not be damaged but that a board sepcific
- * recovery action is needed. If lim_uA is 0 the limit should not
- * be changed but the detection should just be enabled/disabled as
- * is requested.
+ *
+ * - REGULATOR_SEVERITY_PROT should automatically shut down the regulator(s).
+ *
+ * - REGULATOR_SEVERITY_ERR should indicate that over-current situation is
+ * caused by an unrecoverable error but HW does not perform
+ * automatic shut down.
+ *
+ * - REGULATOR_SEVERITY_WARN should indicate situation where hardware is
+ * still believed to not be damaged but that a board sepcific
+ * recovery action is needed. If lim_uA is 0 the limit should not
+ * be changed but the detection should just be enabled/disabled as
+ * is requested.
+ *
* @set_over_voltage_protection: Support enabling of and setting limits for over
* voltage situation detection. Detection can be configured for same
* severities as over current protection. Units of uV.
--
2.27.0
