On 05/03/13 14:55, Russell King - ARM Linux wrote:
On Fri, May 03, 2013 at 01:48:35AM +0200, Sebastian Hesselbarth wrote:
This patch adds an irqchip driver for the main interrupt controller found
on Marvell Orion SoCs (Kirkwood, Dove, Orion5x, Discovery Innovation).
Corresponding device tree documentation is also added.
Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@xxxxxxxxx>
---
Note: This patch triggers a checkpatch warning for
WARNING: Avoid CamelCase: <handle_IRQ>
Changelog:
v1->v2:
- rename compatible string to "marvell,orion-intc" (Suggested by Jason Gunthorpe)
- request mem regions for irq base registers (Suggested by Jason Gunthorpe)
- make orion_handle_irq static (Suggested by Jason Gunthorpe)
- make use of IRQCHIP_DECLARE (Suggested by Jason Gunthorpe)
It would still be a good idea to convert this to use the generic chip
stuff which Thomas created, though exactly how is hard to see at the
moment.
Russel,
that is the plan and that's why the whole patch set is preliminary.
Maybe it would have been more precise to call it RFC instead.
+static void orion_irq_mask(struct irq_data *irqd)
+{
+ unsigned int irq = irqd_to_hwirq(irqd);
+ unsigned int irq_off = irq % 32;
+ int reg = irq / 32;
+ u32 val;
+
+ val = readl(orion_irq_base[reg] + ORION_IRQ_MASK);
+ writel(val & ~(1 << irq_off), orion_irq_base[reg] + ORION_IRQ_MASK);
+}
This could be replaced with irq_gc_mask_clr_bit().
+
+static void orion_irq_unmask(struct irq_data *irqd)
+{
+ unsigned int irq = irqd_to_hwirq(irqd);
+ unsigned int irq_off = irq % 32;
+ int reg = irq / 32;
+ u32 val;
+
+ val = readl(orion_irq_base[reg] + ORION_IRQ_MASK);
+ writel(val | (1 << irq_off), orion_irq_base[reg] + ORION_IRQ_MASK);
+}
This with irq_gc_mask_set_bit().
+
+static struct irq_chip orion_irq_chip = {
+ .name = "orion_irq",
+ .irq_mask = orion_irq_mask,
+ .irq_unmask = orion_irq_unmask,
+};
+
+static int orion_irq_map(struct irq_domain *d, unsigned int virq,
+ irq_hw_number_t hw)
+{
+ irq_set_chip_and_handler(virq, &orion_irq_chip,
+ handle_level_irq);
+ set_irq_flags(virq, IRQF_VALID | IRQF_PROBE);
This is where it starts to get tricky, because I can't see how you'd
merge the irq_alloc_generic_chip() and irq_setup_generic_chip() with
this. Maybe you don't need to do anything here and just do all that
in orion_of_init() instead? But then you seem to need to know the
virq range before hand, and I can't see how that's known. Maybe Thomas
can provide some enlightenment about how the gc irqchip stuff works
with the irq domain stuff...
Exactly, and that is what I am looking into right now. But hell, I am
not an expert in linux irq yet. Moreover, I am not even sure if it is
okay to rely on irqdomain or at least irq_data->hw_irq at all.
My current impression is, that generic chip knowns nothing about irq
domains. But my first modification of it was to use irqd_to_hwirq(d)
where ever it uses d->irq instead. This should allow to abstract from
virtual irqs and retain compatibility (_if_ hw_irq is also set on
!CONFIG_IRQ_DOMAIN).
To add more juice: IRQF_VALID and IRQF_PROBE are ARM only flags. I
tried to find out what they are good for, but stopped googl'ing after
a while. (I know you explained that before somewhere)
However, you wouldn't need the statically defined orion_irq_chip nor
orion_irq_base[] either, because those would be held within the gc
irqchip stuff and stored in the upper layer.
Yeah, that would be very nice. But the current limitation to one
register set with max 32 irqs of generic chip would still require to
keep a list of primary generic irq chips to flip through in the
irq_handler.
This also raises the question, how to check if an generic irq chip
flow handler has to be called. Current irq_chip_regs don't know nothing
about a cause/status register. And actually you don't even know if it
is high/low active and how to mask it with the high/low active mask
register or mask_cache.
Sebastian
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
