On 10/31/12 02:21, Wen Congyang wrote:
> From: Lai Jiangshan <laijs@xxxxxxxxxxxxxx>
>
> Current ZONE_MOVABLE (kernelcore=) setting policy with boot option doesn't meet
> our requirement. We need something like kernelcore_max_addr=XX boot option
> to limit the kernelcore upper address.
>
> The memory with higher address will be migratable(movable) and they
> are easier to be offline(always ready to be offline when the system don't require
> so much memory).
>
> It makes things easy when we dynamic hot-add/remove memory, make better
> utilities of memories, and helps for THP.
>
> All kernelcore_max_addr=, kernelcore= and movablecore= can be safely specified
> at the same time(or any 2 of them).
>
> Signed-off-by: Lai Jiangshan <laijs@xxxxxxxxxxxxxx>
> ---
> Documentation/kernel-parameters.txt | 9 +++++++++
> mm/page_alloc.c | 29 ++++++++++++++++++++++++++++-
> 2 files changed, 37 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
> index 9776f06..2b72ffb 100644
> --- a/Documentation/kernel-parameters.txt
> +++ b/Documentation/kernel-parameters.txt
> @@ -1223,6 +1223,15 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
> use the HighMem zone if it exists, and the Normal
> zone if it does not.
>
> + kernelcore_max_addr=nn[KMG] [KNL,X86,IA-64,PPC] This parameter
> + is the same effect as kernelcore parameter, except it
> + specifies the up physical address of memory range
upper (or maximum)
> + usable by the kernel for non-movable allocations.
> + If both kernelcore and kernelcore_max_addr are
> + specified, this requested's priority is higher than
specified, this parameter has a higher priority than
the kernelcore parameter.
> + kernelcore's.
> + See the kernelcore parameter.
> +
> kgdbdbgp= [KGDB,HW] kgdb over EHCI usb debug port.
> Format: <Controller#>[,poll interval]
> The controller # is the number of the ehci usb debug
> diff --git a/mm/page_alloc.c b/mm/page_alloc.c
> index 5b74de6..9c35fe5 100644
> --- a/mm/page_alloc.c
> +++ b/mm/page_alloc.c
> @@ -200,6 +200,7 @@ static unsigned long __meminitdata dma_reserve;
> #ifdef CONFIG_HAVE_MEMBLOCK_NODE_MAP
> static unsigned long __meminitdata arch_zone_lowest_possible_pfn[MAX_NR_ZONES];
> static unsigned long __meminitdata arch_zone_highest_possible_pfn[MAX_NR_ZONES];
> +static unsigned long __initdata required_kernelcore_max_pfn;
> static unsigned long __initdata required_kernelcore;
> static unsigned long __initdata required_movablecore;
> static unsigned long __meminitdata zone_movable_pfn[MAX_NUMNODES];
> @@ -4715,6 +4716,7 @@ static void __init find_zone_movable_pfns_for_nodes(void)
> {
> int i, nid;
> unsigned long usable_startpfn;
> + unsigned long kernelcore_max_pfn;
> unsigned long kernelcore_node, kernelcore_remaining;
> /* save the state before borrow the nodemask */
> nodemask_t saved_node_state = node_states[N_HIGH_MEMORY];
> @@ -4743,6 +4745,9 @@ static void __init find_zone_movable_pfns_for_nodes(void)
> required_kernelcore = max(required_kernelcore, corepages);
> }
>
> + if (required_kernelcore_max_pfn && !required_kernelcore)
> + required_kernelcore = totalpages;
> +
> /* If kernelcore was not specified, there is no ZONE_MOVABLE */
> if (!required_kernelcore)
> goto out;
> @@ -4751,6 +4756,12 @@ static void __init find_zone_movable_pfns_for_nodes(void)
> find_usable_zone_for_movable();
> usable_startpfn = arch_zone_lowest_possible_pfn[movable_zone];
>
> + if (required_kernelcore_max_pfn)
> + kernelcore_max_pfn = required_kernelcore_max_pfn;
> + else
> + kernelcore_max_pfn = ULONG_MAX >> PAGE_SHIFT;
> + kernelcore_max_pfn = max(kernelcore_max_pfn, usable_startpfn);
> +
> restart:
> /* Spread kernelcore memory as evenly as possible throughout nodes */
> kernelcore_node = required_kernelcore / usable_nodes;
> @@ -4777,8 +4788,12 @@ restart:
> unsigned long size_pages;
>
> start_pfn = max(start_pfn, zone_movable_pfn[nid]);
> - if (start_pfn >= end_pfn)
> + end_pfn = min(kernelcore_max_pfn, end_pfn);
> + if (start_pfn >= end_pfn) {
> + if (!zone_movable_pfn[nid])
> + zone_movable_pfn[nid] = start_pfn;
> continue;
> + }
>
> /* Account for what is only usable for kernelcore */
> if (start_pfn < usable_startpfn) {
> @@ -4965,6 +4980,18 @@ static int __init cmdline_parse_core(char *p, unsigned long *core)
> return 0;
> }
>
> +#ifdef CONFIG_MOVABLE_NODE
> +/*
> + * kernelcore_max_addr=addr sets the up physical address of memory range
upper
> + * for use for allocations that cannot be reclaimed or migrated.
> + */
> +static int __init cmdline_parse_kernelcore_max_addr(char *p)
> +{
> + return cmdline_parse_core(p, &required_kernelcore_max_pfn);
> +}
> +early_param("kernelcore_max_addr", cmdline_parse_kernelcore_max_addr);
> +#endif
> +
> /*
> * kernelcore=size sets the amount of memory for use for allocations that
> * cannot be reclaimed or migrated.
>
--
~Randy
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
