*reg* property and *interrupt* property for "usb_otg_hs" were previously
obtained from ti,hwmods property. But these are now explicitly added
to the dt node. So updated the documentation with these information.
Signed-off-by: Kishon Vijay Abraham I <kishon@xxxxxx>
---
*[PATCH v3 3/3] ARM: dts: omap: Add usb_otg and glue data* adds the dt
data for usb_otg_hs.
Documentation/devicetree/bindings/usb/omap-usb.txt | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/Documentation/devicetree/bindings/usb/omap-usb.txt b/Documentation/devicetree/bindings/usb/omap-usb.txt
index 29a043e..b8551b5 100644
--- a/Documentation/devicetree/bindings/usb/omap-usb.txt
+++ b/Documentation/devicetree/bindings/usb/omap-usb.txt
@@ -2,6 +2,11 @@ OMAP GLUE
OMAP MUSB GLUE
- compatible : Should be "ti,omap4-musb" or "ti,omap3-musb"
+ - reg : Address and length of the register set for the device
+ - interrupts: The interrupt number for the device. It has two interrupt
+ numbers, one for core and one for dma.
+ - interrupt-names: Names of the interrupt corresponding to the interrupt
+ number.
- ti,hwmods : must be "usb_otg_hs"
- multipoint : Should be "1" indicating the musb controller supports
multipoint. This is a MUSB configuration-specific setting.
@@ -19,6 +24,9 @@ OMAP MUSB GLUE
SOC specific device node entry
usb_otg_hs: usb_otg_hs@4a0ab000 {
compatible = "ti,omap4-musb";
+ reg = <0x480ab000 0x1000>;
+ interrupts = <0 92 0x4>, <0 93 0x4>;
+ interrupt-names = "mc", "dma";
ti,hwmods = "usb_otg_hs";
multipoint = <1>;
num_eps = <16>;
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
