Adding details of open drain(open collector) and open source (open emitter) configuration of the gpio so that client can set the pin as open drain at the time of gpio request. Signed-off-by: Laxman Dewangan <ldewangan@xxxxxxxxxx> --- Documentation/gpio.txt | 17 +++++++++++++++-- 1 files changed, 15 insertions(+), 2 deletions(-) diff --git a/Documentation/gpio.txt b/Documentation/gpio.txt index 792faa3..f783e7f 100644 --- a/Documentation/gpio.txt +++ b/Documentation/gpio.txt @@ -302,6 +302,8 @@ where 'flags' is currently defined to specify the following properties: * GPIOF_INIT_LOW - as output, set initial level to LOW * GPIOF_INIT_HIGH - as output, set initial level to HIGH + * GPIOF_OPEN_DRAIN - gpio pin is open drain type. + * GPIOF_OPEN_SOURCE - gpio pin is open source type. since GPIOF_INIT_* are only valid when configured as output, so group valid combinations as: @@ -310,8 +312,19 @@ combinations as: * GPIOF_OUT_INIT_LOW - configured as output, initial level LOW * GPIOF_OUT_INIT_HIGH - configured as output, initial level HIGH -In the future, these flags can be extended to support more properties such -as open-drain status. +When setting the flag as GPIOF_OPEN_DRAIN then it will assume that pins is +open drain type. Such pins will not be driven to 1 in output mode. It is +require to connect pull-up on such pins. By enabling this flag, gpio lib will +make the direction to input when it is asked to set value of 1 in output mode +to make the pin HIGH. The pin is make to LOW by driving value 0 in output mode. + +When setting the flag as GPIOF_OPEN_SOURCE then it will assume that pins is +open source type. Such pins will not be driven to 0 in output mode. It is +require to connect pull-down on such pin. By enabling this flag, gpio lib will +make the direction to input when it is asked to set value of 0 in output mode +to make the pin LOW. The pin is make to HIGH by driving value 1 in output mode. + +In the future, these flags can be extended to support more properties. Further more, to ease the claim/release of multiple GPIOs, 'struct gpio' is introduced to encapsulate all three fields as: -- 1.7.1.1 -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html