Documentation/sound/oss/PAS16:35: ERROR: trailing whitespace Documentation/sound/oss/PAS16:127: ERROR: trailing whitespace Documentation/sound/oss/PAS16:131: ERROR: trailing whitespace Documentation/sound/oss/PAS16:155: ERROR: trailing whitespace Documentation/sound/oss/PAS16:161: ERROR: trailing whitespace Documentation/sound/oss/PAS16:163: ERROR: trailing whitespace Signed-off-by: Andrea Gelmini <andrea.gelmini@xxxxxxxxx> --- Documentation/sound/oss/PAS16 | 12 ++++++------ 1 files changed, 6 insertions(+), 6 deletions(-) diff --git a/Documentation/sound/oss/PAS16 b/Documentation/sound/oss/PAS16 index 951b3dc..fbf0a6a 100644 --- a/Documentation/sound/oss/PAS16 +++ b/Documentation/sound/oss/PAS16 @@ -32,7 +32,7 @@ when answering to these questions since answering y to a question may prevent some later ones from being asked. For example don't answer y to the question about (PAS16) if you don't really have a PAS16. Sound configuration may also be made modular by answering m to configuration -options presented. +options presented. Note also that all questions may not be asked. The configuration program may disable some questions depending on the earlier choices. It may also @@ -124,11 +124,11 @@ CONFIG_SOUND_YM3812 If you compile the driver into the kernel, you have to add "opl3=<io>" to the kernel command line. - If you compile your drivers into the kernel, you MUST configure + If you compile your drivers into the kernel, you MUST configure OPL3 support as a module for PAS16 support to work properly. You can then get OPL3 functionality by issuing the command: insmod opl3 - In addition, you must either add the following line to + In addition, you must either add the following line to /etc/modprobe.conf: options opl3 io=0x388 or else add the following line to /etc/lilo.conf: @@ -152,12 +152,12 @@ I have also included the following append line in /etc/lilo.conf: append="pas2=0x388,10,3,-1,0x220,5,1,-1 sb=0x220,5,1,-1 opl3=0x388" The io address of 0x388 is default configuration on the PAS16. The -irq of 10 and dma of 3 may not match your installation. The above +irq of 10 and dma of 3 may not match your installation. The above configuration enables PAS16, 8-bit Soundblaster and OPL3 functionality. If Soundblaster functionality is not desired, the following line would be appropriate: append="pas2=0x388,10,3,-1,0,-1,-1,-1 opl3=0x388" -If sound is built totally modular, the above options may be +If sound is built totally modular, the above options may be specified in /etc/modprobe.conf for pas2, sb and opl3 -respectively. +respectively. -- 1.7.1.251.gf80a2 -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html