On Wed, Aug 26, 2009 at 01:25:36PM +0200, Pavel Machek wrote: > > you just plain cannot count on writes that are in flight when a powerfail > > happens to do predictable things, let alone what you consider sane or > > proper. > > From what I see, this kind of failure is rather harder to reproduce > than the software problems. And at least SGI machines were designed to > avoid this... > > Anyway, I'd like to hear from ext3 people... what happens on read > errors in journal? That's what you'd expect to see in situation above. On a power failure, what normally happens is that the random garbage gets written into the disk drive's last dying gasp, since the memory starts going insane and sends garbage to the disk. So the disk successfully completes the write, but the sector contains garbage. Since HDD's tend to be last thing to die, being less sensitive to voltage drops than the memory or DMA controller, my experience is that you don't get a read error after the system comes up, you just get garbage written into the journal. The ext3 journalling code waits until all of the journal code is written, and only then writes the commit block. On restart, we look for the last valid commit block. So if the power failure is before we write the commit block, we replay the journal up until the previous commit block. If the power failure is while we are writing the commit block, garbage will be written out instead of the commit block, and so it falls back to the previous case. We do not allow any updates to the filesystem metadata to take place until the commit block has been written; therefore the filesystem stays consistent. If there the journal *does* develop read errors, then fsck will require a manual fsck, and so the boot operation will get stopped so a system administrator can provide manual intervention. The best bet for the sysadmin is to replay as much of the journal she can, and then let fsck fix any resulting filesystem inconsistencies. In practice, though, I've not experienced or seen any reports of this happening from a power failure; usually it happens if the laptop gets dropped or the hard drive suffers or suffers some other kind of hardware failure. - Ted -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html