Firstly, add a switch to allow/disallow debugfs code to be built
into the CCP driver.
This rest of the patch series implements a set of module parameters
that allow fine-tuned control over which CCPs on a system are enabled
by the driver, and how many queues on each device are activated.
Lastly, a switch to enable/disable DMA engine registration is implemented.
The new parameters are also exposed in DebugFS (when enabled).
Details:
nqueues: configure N queues per CCP (default: 0 - all queues enabled)
maxdev: maximum number of devices to enable (default: 0 - all devices activated)
pcidev: Only consider activating devices with the specified PCI ID (default: unset - all devices activated)
buses: Only consider activating devices on the specified PCI buses (default: unset - all devices activated)
dmareg: Register services with the DMA subsystem (default: true)
The maxdev, pcidev and buses parameters aggregate.
Only activated devices will have their DMA services registered.
---
Gary R Hook (11):
crypto: ccp - Make CCP debugfs support optional
crypto: ccp - Add a module parameter to specify a queue count
crypto: ccp - Expose the value of nqueues in DebugFS
crypto: ccp - module parameter to limit the number of enabled CCPs
crypto: ccp - Expose maxdev through DebugFS
crypto: ccp - Specify a single CCP via PCI device ID
crypto: ccp - expose the pcidev module parameter in debugfs
crypto: ccp - module parameter to allow CCP selection by PCI bus
crypto: ccp - expose pcibus module parameter in debugfs
crypto: ccp - Add a module parameter to control registration for DMA
crypto: ccp - Expose the registerdma module parameter in DFS
drivers/crypto/ccp/Kconfig | 9 ++
drivers/crypto/ccp/Makefile | 4 -
drivers/crypto/ccp/ccp-debugfs.c | 3 +
drivers/crypto/ccp/ccp-dev-v5.c | 24 ++++-
drivers/crypto/ccp/ccp-dev.h | 17 ++++
drivers/crypto/ccp/sp-pci.c | 172 ++++++++++++++++++++++++++++++++++++++
6 files changed, 221 insertions(+), 8 deletions(-)
--
