Report errors once when they happen on the I2C bus so we get good information in cases such as when the wrong I2C address is used. Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx> --- ChangeLog v1->v2: - Strip some comments that are now obvious from the context with the error messages. - Do not print the excess ECC error message, atmel_ecc_status() already prints error messages. --- drivers/crypto/atmel-ecc.c | 24 ++++++++++++++++-------- 1 file changed, 16 insertions(+), 8 deletions(-) diff --git a/drivers/crypto/atmel-ecc.c b/drivers/crypto/atmel-ecc.c index 33773920e4bf..baef0d07164d 100644 --- a/drivers/crypto/atmel-ecc.c +++ b/drivers/crypto/atmel-ecc.c @@ -310,26 +310,31 @@ static int atmel_ecc_send_receive(struct i2c_client *client, mutex_lock(&i2c_priv->lock); ret = atmel_ecc_wakeup(client); - if (ret) + if (ret) { + dev_err(&client->dev, "wakeup failed\n"); goto err; + } - /* send the command */ ret = i2c_master_send(client, (u8 *)cmd, cmd->count + WORD_ADDR_SIZE); - if (ret < 0) + if (ret < 0) { + dev_err(&client->dev, "command send failed\n"); goto err; + } /* delay the appropriate amount of time for command to execute */ msleep(cmd->msecs); - /* receive the response */ ret = i2c_master_recv(client, cmd->data, cmd->rxsize); - if (ret < 0) + if (ret < 0) { + dev_err(&client->dev, "getting response failed\n"); goto err; + } - /* put the device into low-power mode */ ret = atmel_ecc_sleep(client); - if (ret < 0) + if (ret < 0) { + dev_err(&client->dev, "putting to sleep failed\n"); goto err; + } mutex_unlock(&i2c_priv->lock); return atmel_ecc_status(&client->dev, cmd->data); @@ -624,8 +629,11 @@ static int device_sanity_check(struct i2c_client *client) atmel_ecc_init_read_cmd(cmd); ret = atmel_ecc_send_receive(client, cmd); - if (ret) + if (ret) { + dev_err(&client->dev, + "failed to send ECC init command\n"); goto free_cmd; + } /* * It is vital that the Configuration, Data and OTP zones be locked -- 2.17.0