In case DECO0 cannot be acquired - i.e. run_descriptor_deco0() fails with -ENODEV, caam_probe() enters an endless loop: run_descriptor_deco0 ret -ENODEV -> instantiate_rng -ENODEV, overwritten by -EAGAIN ret -EAGAIN -> caam_probe -EAGAIN results in endless loop It turns out the error path in instantiate_rng() is incorrect, the checks are done in the wrong order. Cc: <stable@xxxxxxxxxxxxxxx> # 3.13+ Fixes: 1005bccd7a4a6 ("crypto: caam - enable instantiation of all RNG4 state handles") Reported-by: Bryan O'Donoghue <pure.logic@xxxxxxxxxxxxxxxxx> Suggested-by: Auer Lukas <lukas.auer@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Horia Geantă <horia.geanta@xxxxxxx> --- drivers/crypto/caam/ctrl.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-) diff --git a/drivers/crypto/caam/ctrl.c b/drivers/crypto/caam/ctrl.c index 75d280cb2dc0..e843cf410373 100644 --- a/drivers/crypto/caam/ctrl.c +++ b/drivers/crypto/caam/ctrl.c @@ -228,12 +228,16 @@ static int instantiate_rng(struct device *ctrldev, int state_handle_mask, * without any error (HW optimizations for later * CAAM eras), then try again. */ + if (ret) + break; + rdsta_val = rd_reg32(&ctrl->r4tst[0].rdsta) & RDSTA_IFMASK; if ((status && status != JRSTA_SSRC_JUMP_HALT_CC) || - !(rdsta_val & (1 << sh_idx))) + !(rdsta_val & (1 << sh_idx))) { ret = -EAGAIN; - if (ret) break; + } + dev_info(ctrldev, "Instantiated RNG4 SH%d\n", sh_idx); /* Clear the contents before recreating the descriptor */ memset(desc, 0x00, CAAM_CMD_SZ * 7); -- 2.12.0.264.gd6db3f216544