In the Talitos driver, there is a TALITOS_FTR_HMAC_OK flag which is set
only for SEC2.1
Is there any reason for that ?
According to the doc, SEC2 and SEC1 all seems to support HMAC.
However I have tried it on SEC1 and it seems that it doesn't work
properly when wanting to perform a continuation with several descriptors
(which is the case for the last test vector).
And when reading the doc I get confused: the MPC885 Reference Manual
describes a CONT bit in MDEU Mode Register to be used for implementing
continuation mode. The bits seems to be properly set by the driver, but
the result is not the one expected.
Then when I looks into the addendum document AN2912 "SEC Lite Descriptor
Programmer's Guide", the CONT bit is not included in the mode register,
and for the INT bit (which is supposed to be used to initialize for the
first packet of a continuation) it is said it must be set to 1 at all time.
Do you know anything about that ?
Christophe
--
To unsubscribe from this list: send the line "unsubscribe linux-crypto" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
