DMA channel configuration information should be setup in the driver. The Ux500 Cryp driver now does this, so there's no need to send it though here too. Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx> Acked-by: Arnd Bergmann <arnd@xxxxxxxx> Signed-off-by: Lee Jones <lee.jones@xxxxxxxxxx> --- arch/arm/mach-ux500/board-mop500.c | 8 -------- 1 file changed, 8 deletions(-) diff --git a/arch/arm/mach-ux500/board-mop500.c b/arch/arm/mach-ux500/board-mop500.c index ec916ca..38e321c 100644 --- a/arch/arm/mach-ux500/board-mop500.c +++ b/arch/arm/mach-ux500/board-mop500.c @@ -426,20 +426,12 @@ static struct cryp_platform_data u8500_cryp1_platform_data = { .mem_to_engine = { .dir = STEDMA40_MEM_TO_PERIPH, .dev_type = DB8500_DMA_DEV48_CAC1, - .src_info.data_width = STEDMA40_WORD_WIDTH, - .dst_info.data_width = STEDMA40_WORD_WIDTH, .mode = STEDMA40_MODE_LOGICAL, - .src_info.psize = STEDMA40_PSIZE_LOG_4, - .dst_info.psize = STEDMA40_PSIZE_LOG_4, }, .engine_to_mem = { .dir = STEDMA40_PERIPH_TO_MEM, .dev_type = DB8500_DMA_DEV48_CAC1, - .src_info.data_width = STEDMA40_WORD_WIDTH, - .dst_info.data_width = STEDMA40_WORD_WIDTH, .mode = STEDMA40_MODE_LOGICAL, - .src_info.psize = STEDMA40_PSIZE_LOG_4, - .dst_info.psize = STEDMA40_PSIZE_LOG_4, } }; -- 1.7.10.4 -- To unsubscribe from this list: send the line "unsubscribe linux-crypto" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html