While an m_can controller usually already has the init flag from a
hardware reset, no such reset happens on the integrated m_can_pci of the
Intel Elkhart Lake. If the CAN controller is found in an active state,
m_can_dev_setup() would fail because m_can_niso_supported() calls
m_can_cccr_update_bits(), which refuses to modify any other configuration
bits when CCCR_INIT is not set.
To avoid this issue, set CCCR_INIT before attempting to modify any other
configuration flags.
Fixes: cd5a46ce6fa6 ("can: m_can: don't enable transceiver when probing")
Signed-off-by: Matthias Schiffer <matthias.schiffer@xxxxxxxxxxxxxxx>
---
v2: no changes
v3: updated comment to mention Elkhart Lake
drivers/net/can/m_can/m_can.c | 14 +++++++++-----
1 file changed, 9 insertions(+), 5 deletions(-)
diff --git a/drivers/net/can/m_can/m_can.c b/drivers/net/can/m_can/m_can.c
index 012c3d22b01dd..c85ac1b15f723 100644
--- a/drivers/net/can/m_can/m_can.c
+++ b/drivers/net/can/m_can/m_can.c
@@ -1681,6 +1681,14 @@ static int m_can_dev_setup(struct m_can_classdev *cdev)
return -EINVAL;
}
+ /* Write the INIT bit, in case no hardware reset has happened before
+ * the probe (for example, it was observed that the Intel Elkhart Lake
+ * SoCs do not properly reset the CAN controllers on reboot)
+ */
+ err = m_can_cccr_update_bits(cdev, CCCR_INIT, CCCR_INIT);
+ if (err)
+ return err;
+
if (!cdev->is_peripheral)
netif_napi_add(dev, &cdev->napi, m_can_poll);
@@ -1732,11 +1740,7 @@ static int m_can_dev_setup(struct m_can_classdev *cdev)
return -EINVAL;
}
- /* Forcing standby mode should be redundant, as the chip should be in
- * standby after a reset. Write the INIT bit anyways, should the chip
- * be configured by previous stage.
- */
- return m_can_cccr_update_bits(cdev, CCCR_INIT, CCCR_INIT);
+ return 0;
}
static void m_can_stop(struct net_device *dev)
--
TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany
Amtsgericht München, HRB 105018
Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider
https://www.tq-group.com/
