From: John Watts <contact@xxxxxxxxxx>
The Allwinner D1, T113 provide two CAN controllers that are variants
of the R40 controller.
I have tested support for these controllers on two boards:
- A Lichee Panel RV 86 Panel running a D1 chip
- A Mango Pi MQ Dual running a T113-s3 chip
Both of these fully support both CAN controllers.
Signed-off-by: John Watts <contact@xxxxxxxxxx>
---
.../boot/dts/allwinner/sunxi-d1s-t113.dtsi | 30 +++++++++++++++++++
1 file changed, 30 insertions(+)
diff --git a/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi b/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi
index 1bb1e5cae602..b185398334be 100644
--- a/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi
+++ b/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi
@@ -131,6 +131,18 @@ uart3_pb_pins: uart3-pb-pins {
pins = "PB6", "PB7";
function = "uart3";
};
+
+ /omit-if-no-ref/
+ can0_pins: can0_pins {
+ pins = "PB2", "PB3";
+ function = "can0";
+ };
+
+ /omit-if-no-ref/
+ can1_pins: can1_pins {
+ pins = "PB4", "PB5";
+ function = "can1";
+ };
};
ccu: clock-controller@2001000 {
@@ -879,5 +891,23 @@ rtc: rtc@7090000 {
clock-names = "bus", "hosc", "ahb";
#clock-cells = <1>;
};
+
+ can0: can@2504000 {
+ compatible = "allwinner,sun20i-d1-can";
+ reg = <0x02504000 0x400>;
+ interrupts = <SOC_PERIPHERAL_IRQ(21) IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_CAN0>;
+ resets = <&ccu RST_BUS_CAN0>;
+ status = "disabled";
+ };
+
+ can1: can@2504400 {
+ compatible = "allwinner,sun20i-d1-can";
+ reg = <0x02504400 0x400>;
+ interrupts = <SOC_PERIPHERAL_IRQ(22) IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_CAN1>;
+ resets = <&ccu RST_BUS_CAN1>;
+ status = "disabled";
+ };
};
};
--
2.41.0
