Re: [PATCH RFC 0/2] CAN TRANSCEIVER: Add support for setting mux

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi all,

On 11/11/21 10:13 pm, Aswath Govindraju wrote:
> On some boards, for routing CAN signals from controller to transceiver,
> muxes might need to be set. Therefore, add support for setting the mux by
> reading the mux-controls property from the device tree node.
> 
> Aswath Govindraju (2):
>   dt-bindings: phy: ti,tcan104x-can: Document mux-controls property
>   phy: phy-can-transceiver: Add support for setting mux
> 

Thank you for the comments. I have posted a v2 for this series after
making the changes that were requested.

Link to v2,
- https://patchwork.kernel.org/project/linux-phy/list/?series=583917

Thanks,
Aswath

>  .../bindings/phy/ti,tcan104x-can.yaml         |  6 ++++++
>  drivers/phy/phy-can-transceiver.c             | 21 +++++++++++++++++++
>  2 files changed, 27 insertions(+)
> 




[Index of Archives]     [Automotive Discussions]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]     [CAN Bus]

  Powered by Linux