On some boards, for routing CAN signals from controller to transceivers,
muxes might need to be set. Use mux-controls property can be used for model
this.
Signed-off-by: Aswath Govindraju <a-govindraju@xxxxxx>
---
Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
index 6107880e5246..24cc3c04b85d 100644
--- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
+++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
@@ -37,6 +37,11 @@ properties:
max bit rate supported in bps
minimum: 1
+ mux-controls:
+ description:
+ mux controller node to route the signals from controller to
+ transceiver.
+
required:
- compatible
- '#phy-cells'
@@ -53,4 +58,5 @@ examples:
max-bitrate = <5000000>;
standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>;
enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>;
+ mux-controls = <&mux0>;
};
--
2.17.1
